Dicas Reparação




Modelo - Chassis KV2681R


Pesquisa: KV2681R Enviar Dica Resolvida
Resultados 7
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonyKV2681R
IC-301 CHIP SUBSTITUTION, CX-20129 TO CX-20193 The original IC-301: CX20129, part number 8-752-012-90 wastemporarily not available. Tried using CX20193 but picture was rollingvertically. Can this chip be used as a substitute? References: Seeservice bulletin CTV0236 and 24. -HQ COMMENTS: When usin
SonyKV2681R
IC-301 SUB., SEE SB CTV0236 AND TVP0025 When replacing IC-301, the substitute part does not work. -HQ COMMENTS: We have two service bulletins which pertain to the above.Please refer to service bulletin No. CTV0236 and TVP0025 (CSV-1).
SonyKV2681R
SET LOCK UP AT TURN ON, REPLACE R-611 ON A BOARD Set would turn on and off at power switch only. No otherfunction would work. On the X board the only problem that we could findwas no clock on VIP chip IC031. Chip and crystal had been replaced.
SonyKV2681R
NO SOUND, REPLACE T-1104 ON X BOARD Set had no sound. After considerable time spent in tryingto isolate defective part, I determined T1104 had to be open. Bridgingit with a 0.05 capacitor restored sound. By the way, it was very diffi-cult to trace audio to determine where the problem wa
SonyKV2681R
DEAD, RESOLDER T-501G Dead. Set does not turn on at all. No signal at base ofhoriz. out. Q504. However, there is signal at Q503 collector.
SonyKV2681R
NO RASTER/SOUND, HI VOLTAGE OK, LEAKY C-049 ON X BOARD Set could be turned on, H.V. would come on but no raster, nosound. Found no reset at Pin 18 of IC031 on X board. This is thesecond set I have worked on with this problem and the same part wasdefective.
SonyKV2681R
DEAD, REPLACE T-501 AND Q-504 Unit was dead due to one leg of T501 was shorted to groundwhich in turn took out the H. output transistor.


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads