Dicas Reparação




Modelo - Chassis KV1217


Pesquisa: KV1217 Enviar Dica Resolvida
Resultados 8
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonyKV1217
UPC1358H, SUB TO UPC1368H2 After replacing the vertical output IC twice, we still had novert. operation. We tried using an RCA substitute P/N SK-9180. This IChas worked fine. -HQ COMMENTS: We do not usually recommend using a non Sony replacementpart - but the UPC1358's substit
SonyKV1217
UNIT SHUTS DOWN, RESOLDERED R515 Unit keeps shutting off after turn on.
SonyKV1217
SHUT DOWN, CLEANED AND ADJUSTED HOR. FREQ. CONTROL Set going into HV shut down intermittently when turned on.Set would also horizontal freq. adjustment was on very edge of locking.
SonyKV1217
VERTICAL FOLDOVER, REPLACED C524 Vertical foldover with blanking spot on right upper corner andjittery picture. Found C524 installed backwards during manufacturing.
SonyKV1217
NO UHF, REPLACED TUNER No UHF.
SonyKV1217
PICTURE DISTORTION, SEE MODIFICATION BELOW Horiz. centering adjustment will not shift picture far enoughtowards the right. Center adjustment only expands the picture. -HQ COMMENTS: Try the following circuit modification. Place the horiz.centering R. position. The R1, R2, C1 values shown shoul
SonyKV1217
DEAD, REPLACED Q602 No sound, no picture, channel indicator stays in one position,tuning and band indicators are dim. Found regulator transistor Q602leaky, and both audio output transistors Q205 and Q206 shorted also R232open.
SonyKV1217
INCORRECT TUNING OPERATION, REPLACED R078 In program mode, pressing tune-up button would cause a changein address position only and could not program any channels. Also, nochannels could be put into or removed from memory.


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads