Dicas Reparação




Modelo - Chassis KV10FMR20


Pesquisa: KV10FMR20 Enviar Dica Resolvida
Resultados 10
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonyKV10FMR20
NO AUDIO, REPLACED C252 Unit had no audio in FM/Video or TV mode. Discover defective capacitor C252 on Y PC board. -HQ COMMENTS: C252 filter cap is located on the Y board on the9v supply line. Schematic grid location B-5
SonyKV10FMR20
NO POWER, REPLACE POWER SUPPLY COMPONENTS, SEE S/B 200 No Power.
SonyKV10FMR20
NO TV OR VIDEO MODE ONLY RADIO, REPLACED IC-101 The unit works in FM mode only, no TV or Video mode.IC-101/pin 8 did not go High (8.8v. TV power) did not turn on the 9v(regulator Q107). Which supplies the VCC for IC-301pin 9 (horizontalosc.)
SonyKV10FMR20
INTERMITTENT PICTURE AND SOUND, REPLACED IC301 JUNGLE Intermittent picture and sound .
SonyKV10FMR20
NO PICTURE - HAS SOUND, REPLACED R835 No TV channels - video inputs work fine, but verticaldeflection was shortened at top and bottom.
SonyKV10FMR20
SHUT DOWN, REPLACED THE FLYBACK TRANSFORMER Set will shut down when it gets really hot. When you removedall the case cover, the set will run forever.
SonyKV10FMR20
NO HIGH VOLTAGE - HAD SOUND IN RADIO MODE No high voltage.
SonyKV10FMR20
WILL NOT HOLD ANY MEMORY Will not hold any memory. Must reset all channels, volume andall secondary controls everytime you turn unit on. These controls are allin max position upon turn on.
SonyKV10FMR20
RESISTOR R-646 NOT LISTED IN SERVICE MANUAL Have a unit with a defective R-646. This resistor is notshown in the schematic or listed in the parts listed. Please advise. -HQ COMMENTS: According to Tokyo, this value should be 100 ohms.This resistor is in parallel with R-617 (located on the schema
SonyKV10FMR20
NO PICTURE Y signal not passing through Q-302. Q-304 is on, should beoff. D-301 and D-303 reverse - biased.


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads