Dicas Reparação




Modelo - Chassis KPR53EXR15


Pesquisa: KPR53EXR15 Enviar Dica Resolvida
Resultados 7
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonyKPR53EXR15
AP
DEAD KPR53EXR15. Unit had no power Unit has Q603 and Q614 are shorted. When all are replaced only Q614 shorts. Tech needs to apply power to this unit easily, with the use of a variac. While watching current go up gradually. Suggest that the ""D"" board be disconnected and see if it will turn on with no more than 1 amp of current. It did not. An Amp of current was reached at 38 vac.. Further checking found a ""Muller
SonyKPR53EXR15
CENTER OF SCREEN FOGGY, REPLACED DIFFUSION PLATE 403646902 Center of screen on frenzel is foggy. Sending in moresamples. No unusual circumstances, a/c on most of the time insidebedroom with no direct light.
SonyKPR53EXR15
CONNECTOR A6, G6 MISSING, SEE SB # 145 On the new G Boards connector A6-G6 is missing. -HQ COMMENTS: Please see Service Bulletins 145, and 216. 1. Remove the wiring harness completely which goes between the connectors A-6 and G-6. These connectors are located between
SonyKPR53EXR15
TWO TYPE OF CRT'S USED, NOT INTERCHANGEABLE - SEE S/B 190R1 Two types of CRT's used. -HQ COMMENTS: Silicon tubes were used in most of the units butduring production the tubes were switched to the Mechanical type. Mechanical tubes were used approximately between serial numbers: Start End 9,002,691
SonyKPR53EXR15
FREEZE MODE IS ACTIVATED BY VCR (SLV595HF) REMOTE RMTV1121 Using the remote(RMTV112A) from SLV696HF and activiting therewind function causes the KPR53EXR15 to go to the freeze mode. -HQ COMMENTS: We check a KPR46EXR15 in PR along with the RMT-V112A andhad no trouble. We feel the problem is in the micro or ROM.
SonyKPR53EXR15
VERY DARK MAIN PICTURE, CHILD PIX OK.,REPLACED IC2301 (E2)
SonyKPR53EXR15
SPOT ON THE PHOSPHOR OF THE CRT, OPEN R-898 (N BOARD) Spot on the CRT phosphor.


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads