Dicas Reparação
Modelo - Chassis KP61V15
Pesquisa: KP61V15 Enviar Dica Resolvida
Resultados 7
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | KP61V15 AP | ARCING | TV will turn on but the Front panel LED will continually blink on and off. Unit gets high voltage but has a lot of arcing around the High voltage distribution block. Unit does have sound and has vertical sweep. The chassis is heavily corroded due to the environment. Unit is located next to an open window that receives ocean spray from the surf. | After closer inspection tech found the focus screen block assembly wires were falling off of the assembly. Cleaning the connections with water and thoroughly drying the connections then resoldering them to the block assembly corrected the fault. | Muller |
| Sony | KP61V15 | G BOARD AND A BOARD HAS +135 PRINTED ON BOARDSWRONG | Connector G2 (G board) and connector A2 (A Board) have +135printed on them. This is incorrect the true voltage is +115v DC. The-135 volt line is correct. | ||
| Sony | KP61V15 | PARTS NUMBER FOR MIRROR | Part number in service manual for V15, AP chassis, and V25, RA chassis are listed differently. Such as in V15, AP, 53 and 61use same part number but V25, RA shows 46 and 53 are same part number. -SOLUTION : Service ma | ||
| Sony | KP61V15 | GLASS DOOR HINGES AND SCREWS, PART NUMER NEEDED | Glass door hinges or mounting screws are not availableseparately. Glass block assembly must be ordered, part numberX-403-295-21, which includes all of the above. | ||
| Sony | KP61V15 | "D" AND "DS" BOARD CHANGED, REFER TO THE KP-46S55 S/M | The Service Manual shows the DS Board has three IC mountedon it. The one in the unit only has one IC. -HQ COMMENTS: Both the D and DS boards have been changed. Theyare not interchangeable. Please refer to the KP-46S55 for the correctschematic, page | ||
| Sony | KP61V15 | MECHANICAL SEALED TUBE SUB TO SILICON | What type of CRT were used in this chassis? -HQ COMMENTS: This model only used the Mechanical sealed type CRT's.They can be replaced with the Silicon type, but a ground spring MUST beadded to prevent the CRT from arcing. Please refer to the ServiceBull | ||
| Sony | KP61V15 | SHUTDOWN, REPLACED C1718 ("D" BOARD) | TV is very hard to trouble shoot due to very poor design.Request follow-up for a better way to work on TV. |