Dicas Reparação
Modelo - Chassis ITD200
Pesquisa: ITD200 Enviar Dica Resolvida
Resultados 10
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | ITD200 | LOW SPEAKER PHONE - REPLACE SP1, P/N 1-544-480-11 | Low audio coming out of SP1. I found out that speaker made inMalaysia has low audio output. | ||
| Sony | ITD200 | MAIN BOARD COMPATABILITY | Ordered replacement main board for ITD200. Received board andfound different ribbon cable to one touch bd. Instead of a 10pin and a 14 pin socket as on the original. Part # on original #163445121 Part # on Replacement | ||
| Sony | ITD200 | DIFFERENT SIZE OF NEW SPEAKERS. | I tried twice to replace speaker SP1, p/n 1-503-819-11, but itdid not fit in the unit, as it is slightly too big. When I tried to orderspeaker p/n 1-544-480-11 as per Telephone Products Service Bulletin No.107, I got instead speaker, p/n 1-503-905-11, wh | ||
| Sony | ITD200 | LOW OR NOT AUDIO IN SPEAKER PHONE OR HANDSET - CHANGE C-318. | Very low dial tone in handset and speaker phone, touch toneDTMF is heard in the handset when dialing. | ||
| Sony | ITD200 | HANDSET MUTES WHEN EXTENSION PHONE IS PICKED UP | Handset mutes when extension phone is picked up. This iscaused by line loading. The 12V off-hook line voltage of this unit getsloaded down to less than 6 volts when an extension phone is picked up.This unit will stop working at a line voltage less than | ||
| Sony | ITD200 | NO TONE DIAL - REFLOW C-334 | The unit would not tone dial. I found C334 open (coldsoldered). | ||
| Sony | ITD200 | UNIT WON'T HANG UP | Unit would not go On Hook. The keyboard, handset,speakerphone otherwise operated normally. | ||
| Sony | ITD200 | MISSING PART NUMBER FOR BZ1 AND BZ2 | There are no part numbers for BZ1 and BZ2 in the servicemanual. -HQ COMMENTS: The 2 buzzers BZ1 and BZ2 are not available as separateitems. However they are part of the lower cabinet assembly.Therefore, if you need to replace BZ1 or BZ2, you will have t | ||
| Sony | ITD200 | PART NUMBERS OF REF NUMBERS 57 AND 58 | the part numbers for the CONF and HOLD buttons, ref # 57 and58 are not listed in the service mabual. | ||
| Sony | ITD200 | IMPEDANCE OF SONY TELEPHONE PRODUCTS | What is the impedance of our phone products? -HQ COMMENTS: All Sony phones fall in the range of 50 to 300 Ohms whenthe phone is off-hook and when DC-loop current is in the range of 15 -120 ma. |