Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | ITA205 | NO OGM & MEMO RECORDING REPLACE C513, P/N 1-124-584-00. | Unit will not record OGM or Memo. C513 is shorted to groundpreventing the mic signal (MIC 501) from entering the pre amp (IC503). | ||
Sony | ITA205 | NO ANSWER MACHINE FUNCTION | Unit was unable to do any answer machine function (FF, REW,PLAY, OGM). Checked VCC and RESET. Both were correct. Checked forcrystal (X-601) at pin 24 and pin 25 of IC-602 and found no frequency.Found X-601 open. | ||
Sony | ITA205 | UNIT WILL NOT PLAY BACK MEMO THROUGH REMOTE FUNCTION | During remote operation when control code *1 is pressed, thememo does not play back, but when control code #1 is pressed, the memo isplayed back. Also applies to serial number 502413 and 505942. | ||
Sony | ITA205 | UNIT RINGS BUT DOES NOT CONNECT WITH OUTSIDE LINE | Unit would not connect with outside line. No audio transferor dial function but phone would ring. Also applies to serial numbers209376 and 108991. | ||
Sony | ITA205 | DISTORTED AUDIO-TAPE DECK | Defective motor causing wow and flutter in the tape deck.Also applies to serial number 232347. | ||
Sony | ITA205 | NO OGM OR ICM RECORDING | Have found several units in which CN-3 was not properlymounted in the main board before soldering. In one (ser. No. 198352) pin1 was open between IC-602/28 and IC-605/41 preventing OGM record. Inothers, pin 10 was open or intermittent preventing the (I | ||
Sony | ITA205 | NO TAPE MOTION | Tape would not play. | ||
Sony | ITA205 | WILL NOT ANSWER INCOMING CALLS | |||
Sony | ITA205 | WILL NOT ANSWER INCOMING CALLS | Customer complains of unit not answering incoming calls. Unitworks fine in shop. Most of these that we have seen are when the customerlives in a smaller community or rural area. These answering machines seemto have a problem detecting the ring on some | ||
Sony | ITA205 | INSTANT HANGUP | When unit answered the ring, it would grab the line momentar-ily and release it. IC-401 pin 19 was not supplying the .7 volts to thebase of Q-106, which is necessary to operate the O.G.M. interupt detectcircuit. This in turn would not allow PH-604 to a | ||
Sony | ITA205 | IC-201 PIN OUT IS INCORRECT | The pin out of IC-201 is wrong in the unit. The servicemanual is correct. | ||
Sony | ITA205 | NO POWER ON | No power on. | ||
Sony | ITA205 | BATTERY DOES NOT FIT CORRECTLY | This is a replacement battery. The legs are too wide to mountin the board. |