Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | GEN-CAM | LANC JIG HARDWARE COMPONENT VALUE CHANGES - D3, D4, R1 | Two incorrect diodes were installed in the LANC jig. Thisaffects 100 units and should be checked and corrected if necessary. | ||
Sony | GEN-CAM | LANC JIG SOFTWARE UPDATE VERSION 2.1B NOW AVAILABLE | An update to the LANC jig software is now available. The newversion is 2.1b. | ||
Sony | GEN-CAM | LANC JIG SOFTWARE UPDATE VERSION 2.1A NOW AVAILABLE | An update to the LANC jig software is now available. The newversion is 2.1a. | ||
Sony | GEN-CAM | LANC JIG/ SERVICE BULLETIN | How will the authorized and non authorized servicers whopurchased the lanc jig be notified when there is updated software that Iassume must be available periodically. Also, are these updates availablethrough Parts Department? -HQ COMMENTS: Service Bulle | ||
Sony | GEN-CAM | PART NUMBER FOR ANTI-STATIC MAT/T-9985-198-1 | What is the part number for the 3M Anti-Static Bench Mat? | ||
Sony | GEN-CAM | LANC JIG ON BACKORDER/BEG. MAY 1993 | The Lanc Jig is on backorder with 0 shown in transit. Couldsomeone be contacted to expedite part number T-998-548-61, Lanc Jig? -HQ COMMENTS: Delivery to KC should be on or about the beginning of May1993. | ||
Sony | GEN-CAM | SERVICE TOOL | When replacing No. 6 tape guide, it is very difficult toloosen the screw that holds this guide in place. By taking the screw-driver bit No. 7-700-752-01 heating it and bending it at a 90 degree angleit is very easy to get to this screw. We did this at | ||
Sony | GEN-CAM | INCORRECT CATEGORY FOR SERVICE BULLETIN VID0127 | Shouldn't this bulletin be in the CSV-3 category? The onlymodels listed are cameras. -HQ COMMENTS: Yes, you are correct, this should be in the CSV-3category. We will issue a revision (VID0127R). | ||
Sony | GEN-CAM | LITHIUM BATTERY CR-2025 | I need the part number of lithium battery CR-2025 without tab.GV-8 uses CR-2032 part number, 152-817-431. I tried on camera and itworks fine but hard to remove because CR-2032 is thicker thanCR-2025. -HQ COMMENTS: There is no part number registered for | ||
Sony | GEN-CAM | MODE SELECTOR III CONVERSION CONNECTOR CABLE ASSEMBLY | This part is necessary to hook up the mode select box to test8mm mechanical assemblies. It is replaced by a new version - Part No:J-6082-021-A. -HQ COMMENTS: Please refer to the 8mm Video Mechanical Adjustment ManualII on page 6. | ||
Sony | GEN-CAM | PART NUMBER FOR POWER CORD | What is the part number for the cord which connects AC poweradaptor to the camcorder? -HQ COMMENTS: The part number for the cord which connects an AC poweradaptor to the camcorder is 1-559-354-21. | ||
Sony | GEN-CAM | 8MM LAPPING TAPE | What is the part number for the 8mm lapping tape? -HQ COMMENTS: The part number for the 8mm lapping tape is 8-883-103-10. |