Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | CFSD960 | WRONG RESISTOR VALUE ON SCHEMATIC | After replacing defective output IC and limiting resistor,there was no sound due to low supply voltage to output and bass amp ICs.Resistor is marked 3.9K instead of 3.9 Ohms. Part number and descriptionare correct on parts list. Low voltage was, of cou | ||
Sony | CFSW50 | (MD) BOARD | The (MD) board in this unit does not correspond to theschematic. Do we have any additional information? If so, please Fax tothe Minneapolis SSC. -HQ COMMENTS: We have no additional information on this at this time,and we have not had any other complai | ||
Sony | CFS212 | INCORRECT PART NUMBER IN SERVICE MANUAL | Part number in service manual (page 13, reference No. 5)X-3344-323-1, is incorrect. | ||
Sony | CFS210 | WILL NOT WORK ON AC | Will not operate on AC. | ||
Sony | CFS220 | NO TAPE AND/OR BATTERIES GOING DEAD | Unit will have no tape functions and/or will have a constantcurrent draw on battery or AC power supply, even in the OFF position.This will cause battery to go dead in approximately three days. | ||
Sony | CFSW501 | 10KHZ NOISE IN HIGH SPEED DUBBING | A 10KHz noise is heard only in high speed dubbing. All otherRecord, Playback functions ok. | ||
Sony | CFSD550 | PLAY BUTTON JAMS | Plate under head deck is warped. Also S/N 59900 and 60492. -HQ COMMENTS: KCP has an improved part. Please exchange the play lever. | ||
Sony | CFSD20 | DIRECTION LEVER STICKS/INOPERATIVE | Orange wire between S401-3 and (MD) board gets caught betweenwiring guide D (230) and button (9) on manual button lever (218). Some-times the button pushes the wire out of the way, other times not. | ||
Sony | CFSW360 | MISSING PART NUMBERS IN SERVICE MANUAL | No part numbers listed for capacitors and resistors. Seepages 25, 26, 27 and 28. -HQ COMMENTS: We asked Tokyo about this problem. As soon as we get aresponse, we will issue a service bulletin. | ||
Sony | CFSW501 | BATTERY LEAKING SHORTLY AFTER INSTALLATION | Battery is leaking, getting hot and going dead caused by theDC cut-off switch in the AC power plug. This causes DC from the powersupply to go into the batteries. | ||
Sony | CFSW301 | BATTERY LEAKING SHORTLY AFTER INSTALLATION | Battery is leaking, getting hot and going dead caused by theDC cut-off switch in the AC power plug. This causes DC from the powersupply to go into the batteries. | ||
Sony | CFS212 | TAPE STICKS AND WILL NOT EJECT | Tape shell is catching on head and pinch roller upon eject.As best I can tell, the head plate is fully retracting, although stickingis sometimes noticed. Either way, tape gets stuck. Please advise.Several units all have same problem. Also S/N 21155. | ||
Sony | CFS920 | MISSING MOISTURE SEAL AROUND CASSETTE DOOR AND BATTERY DOOR | A dealer complained that the new shipment of CFS-920s weremissing the (o) ring gaskets on the cassette door and battery door. Thedealer showed me an earlier S/N (31888) with the seals installed. Hasthere been a change in this model? These serial numbe | ||
Sony | CFS920 | BROKEN BATTERY TERMINAL BOARD | Battery terminal board broken. This board has been foundbroken on two other units within three months. Also, when ordering partnumber 1-622-407-11 (negative battery terminal board) positive batteryterminal board number 1-622-408-11 is received, Ref. No | ||
Sony | CFSW500 | BAD SOLDER JOB ON A.C. JACK | Poor soldering on A.C. jack resulting in no power from batter-ies or A.C. cord. If problem persists, should notify proper personnel.Same problem was found on serial number 111721. -HQ COMMENTS: Thank you for your information. We will inform Tokyo ofth |