Dicas Reparação
Modelo - Chassis FD2A
Pesquisa: FD2A Enviar Dica Resolvida
Resultados 17
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | FD2A | INCORRECT IC CASE STYLE, IC201 | The original part listed above is substituted to 8-759-602-XX.This substitute part is a suface mount device. The orginal part is a PCMount Device. The leads are too short to mount on the printed circuitboard. Original part is 8-759-602-99. Replacemen | ||
| Sony | FD2A | TV INTERMITTENTLY NO PICTURE, REPLACED S-151 | Picture comes and goes intermittently. | ||
| Sony | FD2A | PICTURE LOOKS OUT OF FOCUS, REPLACED C555 | Picture appears as raster only, out of focus. In reality, thesweep is displaced far above the top of the tube due to DC level upsetcaused by shorted C-555. | ||
| Sony | FD2A | D-I BOARD REPLACEMENT DOES NOT MATCH THE SERVICE MANUAL | D-1 replacement board does not match the service manual. -HQ COMMENTS: Service Manual Correction has been published.Please refer S/M correction-1. | ||
| Sony | FD2A | WRONG P/N FOR L201 | Wrong P/N in FD2A manual for L201. I believe it should be1-408-098-00 same as FD20. -HQ COMMENTS: We will publish correction on this. | ||
| Sony | FD2A | NO SOUND, REPLACED C215 | All units no sound. Found C215 leaky or shorted. Expect tosee more. Servicer has 40 with same no sound. | ||
| Sony | FD2A | NO FOCUS, RESOLDERED C806 | Picture out of focus, unable to adjust, traced problem toC806. Found one side of filter capacitor not soldered. | ||
| Sony | FD2A | NO RASTER, SHORTED ELECTROLYTICS C209, C215, C611 | No raster, no sound. Found one or more of the aboveelectrolytics shorted. | ||
| Sony | FD2A | SCALLOPING ON LOWER THIRD, REPLACED IC851 | After the set had been on for about 30 - 60 minutes the lowerthird of the screen developed a scalloped appearance which gradullybecame more severe. We found the problem to be IC851. | ||
| Sony | FD2A | DEAD, REPLACED Q602, IC601, T601 | Unit was dead. Replacing Q602 and IC601 restored raster, butsound and picture were weak. | ||
| Sony | FD2A | CX20159 DEAD | Unit came in with dead CX20159. Tech replaced it and thiscauses Q602 and associated components to burn up. -HQ COMMENTS: Since IC601, Q602 are part of power supply circuit weshould first check its most suspect components before turning power on.Next, | ||
| Sony | FD2A | MISSING PART # FOR DIAL POINTER IN S/M | Missing part # for dial pointer in S/M. -HQ COMMENTS: The dial pointer is a part of the front cabinet. | ||
| Sony | FD2A | INT FOCUS, REPLACED FLYBACK | Harlan Mauer of the Mpls. SSC reports FD-2AThe problem is traced to a defective flyback. | ||
| Sony | FD2A | NO SOUND, REPLACED C215 | No sound, but picture OK. Pin 9 goes to 0V. Pin 13 audioout no signal. Replaced IC201, did not solve problem. Measured fromPin 9 to GND to see capacitor is charging or not. | ||
| Sony | FD2A | NO PICTURE, NOR SOUND, REPLACED C209 | No video, nor sound. Q601 get hot. Found C209 bad. |