Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | FD10A | RASTER BUT NO VIDEO, REPLACED BAND SW, 1-570-377-11 | Raster no video. | ||
Sony | FD10A | NO TUNING BAND SWITCHING, REPLACED SWITCH S-151 | Won't switch bands. | ||
Sony | FD10A | NO PICTURE, REPOSITIONED R-868 | Low G-2 voltage. The copper trace under the R-868 isconducting partially to resistor connection. | ||
Sony | FD10A | NO HORIZONTAL SYNC, REPLACED C504 | Inoperative phase detector, 0vdc at pins 16, 17 and 18 ofIC-501. Found shorted C-504. | ||
Sony | FD10A | PART NUMBER FOR DIAL POINTER | Part number for dial pointer is missing from the servicemanual. -HQ COMMENTS: There is no separate part number for the dial pointer.This pointer comes as part of the front cabinet. Please see the ServiceManual Supplement No. 1, issued in October of 86, | ||
Sony | FD10A | NO PICTURE AND BATTERY MELTED CABINET | Unit had no picture but sound was ok. Found no pulse to Q-805F.B.T. drive transistor. This transistor becomes very very hot to thepoint of melting the solder on it. Current being drained from thebatteries becomes very high resulting in damage to the c | ||
Sony | FD10A | NO HORIZONTAL SYNC, REPLACED C506 | No horizontal sync. OV at pins 17 and 18 of IC-501 causingphase detector inoperation due to shorted C-506 (pin 15, also 0 volts). | ||
Sony | FD10A | NEW BACK PLATES DO NOT FIT OLDER UNITS | Older FD-10A (i.e. - 1986 models) were manufactured in Japan,newer models were made in Taiwan. Band SW is in different positioncausing a misfit of replacement plates on older units. -HQ COMMENTS: Cabinets (rear) assembly for both old and new FD10A area | ||
Sony | FD10A | NEW FLYBACK TRANSFORMER USES NO SILICORE SEALANT | New replacement parts are different from original. -HQ COMMENTS: Thank you for your report. I contacted Japan, and theyare checking the part compatibility. We anticipate the reply shortly. Iwill inform you of the solution as soon as I receive it. Pe |