Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | EVS7000 | NO INFO ON THE MODE SWITCH STATES... | There is no info on the mode switch states. there is no way to know if the switch is operating properly. Is there any information anywhere on the switch? -HQ Comments: We received the info 7/8. A service bulletin is in | ||
Sony | EVS7000 | WON'T STOP AT END OF SCENE - REPLACED DRUM | Cust complaint could be: 1. Tape won't stop at end of scene 2. Timing is off at start and end of previously marked scenes 3. Skipped some scenes entirely 4. Intemittently, next time scenes might come up as requ | ||
Sony | EVS7000 | EATS TAPES - REPLACED MODE SWITCH | Put tape in unit no drum would spin up. unit would eat tape. Unit's guides would load tape with no drum rotation causing unit to eat tapes. | ||
Sony | EVS7000 | NO VIDEO OUT, BLUE SCREEN ONLY - REPLC LPF FL103(VI-131 BD) | unit did not have any video outputs (E-E or playback). Traced signal to Low Pass Filter, FL103, on VI-131 board. | ||
Sony | EVS7000 | INT. BLUE LINES IN PIX - REPLACED X500 ON DI-51 DIGITAL BD | Int. blue lines in picture after warm up in play. | ||
Sony | EVS7000 | AUDIO DROPOUT WITH FUJI TAPES RECORDED ON CCD-TR200 | Audio drop out with Fuji tape recorded on CCD-TR200. This would happen only with Fuji tape which was recorded on CCD-TR200 and played back on the EVS-7000. | ||
Sony | EVS7000 | NO DISPLAY - REPLCE OPEN R208/100K ON FM16 BOARD | No display. | ||
Sony | EVS7000 | INTERMITTENT DROP-OUT OF TIME CODE. VIDEO OK | Time code display would intermittently drop out during PB onMP120 tape. This time code had been recorded on the same machine, usingthe TIME CODE WRITE function. While the picture looked OK, the envelopeshowed entrance and exit side abnormalities. The pr | ||
Sony | EVS7000 | EATS TAPES IN JOG/SHUTTLE MODE. | unit intermittently sticks injog/shuttle mode. Found defective rotary mode switch. SOLUTION: replace mode switch. | ||
Sony | EVS7000 | INTERMITTENLY DOES NOT LOAD OR EJECT | Intermittent loading or ejecting failure. Found defective mode switch. SOLUTION: Replace rotary switch. | ||
Sony | EVS7000 | EATING TAPES | Unit would intermittently eat tapes, found take up torque uparound 28 G. | ||
Sony | EVS7000 | INTERMITTENT DISTORION IN VIDEO | Intermittent lines in video, eats tapes during rewind. Found forward torque higher then 20g.cm. | ||
Sony | EVS7000 | DISTORTED PICTURE AFTER REW/FF | Dropouts in video after rew/ff or Q review. | ||
Sony | EVS7000 | DISTORTION IN VIDEO PLAYBACK (FRAME BY FRAME) | Distortion in frame by frame review. | ||
Sony | EVS7000 | NO S VIDIO INPUT ON L1/CHECK SET-UP MENU | Line one has no S video input |