Dicas Reparação




Modelo - Chassis EVC8U


Pesquisa: EVC8U Enviar Dica Resolvida
Resultados 12
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonyEVC8U
SNOWY PICTURE EVERY TWO OR THREE SECONDS Every 2 or 3 seconds the picture would become snowy. Soundremained OK.
SonyEVC8U
SERVO SPEEDS UP WHEN PAUSE IS RELEASED The capstan servo speeds up when pause is released thensettles to normal play.
SonyEVC8U
CAMERA RECOGNITION AND TALLY OPERATION 1) How does the EV-C8U know when a camera is connected?2) Is the tally output at camera connector CN807 pin 9 active whenconnecting a line input via the multipin connector? -HQ COMMENTS: 1) Via the serial control bus at camera connector CN807pin 7. 2)
SonyEVC8U
NOISY PICTURE (PLAYBACK) Tape recorded on this unit played back ok on another unit. InPlayback mode, picture very noisy, looked like a de-tuned picture fromtuner. Inspection revealed excessive noise on pins 12 and 13 of IC-101,AR-4 board. Also, noise present on 5 volt line on
SonyEVC8U
NO THREADING OF CASSETTE TAPE No tape threading. Loading motor moves.
SonyEVC8U
NEED TO FEED MIC INPUT TO 12 PIN CAM CONNECTOR Need to feed mic input to 12 pin cam connector. Refer topage 96 S/M. CN113, Pin 2 Mic CN007, Pin 7 Cam/LineHow to switch to mic? -HQ COMMENTS: This 12 pin connector is a multi-connector with manyapparent applications. There is a serial control L
SonyEVC8U
NO PART NUMBER FOR FLEX CONNECTORS Can not find P/N for flex connectors shown in explodeddiagram on page 101. -HQ COMMENTS: Connector part numbers are listed on pages 108 and 114 ofS/M. Part numbers are 1-557-555-11 (CN509, SV-13) and 1-562-583-11(CN506, MC-4).
SonyEVC8U
NO VIDEO PB 1) Unit had no playback video - just intermittent flashes.2) Poor sync and rainbow in picture.
SonyEVC8U
COUNTER DOES NOT WORK Counter does not work.
SonyEVC8U
DISTORTED VIDEO Video looked very cloudy - no high freq.
SonyEVC8U
NO EJECT Unit would load OK. Play tape for a few seconds then stop.FF or REW would run for a short time then stop. When eject was pushed thetape would unthread, but cassette compartment would not come up. The modeswitch was not running, it was staying in the l
SonyEVC8U
NO EJECT AND SHUTDOWN DURING PLAYBACK 1) Tape unthreads during eject mode, but will not unload.After unthreading eject LED blinks. 2) During playback, unit stops afterabout 10 sec and eject LED blinks.


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads