Dicas Reparação




Modelo - Chassis D555


Pesquisa: D555 Enviar Dica Resolvida
Resultados 11
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonyFD555
COMPLETE LOSS OF AUDIO, REPLACED IC701 Found Q451 & 452 turned ON. IC701/pin 10 read 12v.
SonyFD555
INTERMITTENT LOSS OF CHANNELS, REPLACED RV151 Cannot tune in tuning voltage for channels 5, and 7.
SonyFD555
TV FUNCTON IS DEAD, REPLACED C504 All functions working except tv.
SonyFD555
DARK TUBE, REPLACED CRT Dark tube from dealer stock. I believe that this is a displaypiece and tube went soft.
SonyFD555
NO PICTURE RASTER ONLY, REPLACED L151 No picture, raster only.
SonyFD555
NO TV OPERATION, REPLACED C504 AND C557 C504 and C557 have failed on a couple of units. I believethat the voltage rating is too low causing this capacitor to short. -HQ COMMENTS: We have not received any reports other than yoursof this failure. Please measure with a scope across the capacit
SonyFD555
TAPE MOTOR RUNS CONSTANTLY, REPLACED S301 (TAPE MOTOR DRIVE) Tape motor runs constantly, even with tape funtion buttonsreleased. Found S301 shorted in all 3 units. In the first (224725) theleaves of the switches were touching. In the second (222030) the wireheads from CN302 were twisted 180 degrees and touching
SonyFD555
INTERMITTENT PICTURE, AND BRIGHTNESS. RESOLDERED C803 The unit would intermittently loose picture or brightnesslevel, when touching the board it would change. The horizontal osc.signal level changed between the positive and negative side of C-803horizontal drive couplying capacitor which delivers the horiz
SonyD555
IC-502 HAS FEWER PINS THAN LANDS ON SERVO BOARD IC-502 is a 12 x 4 flat pack, CXA1272R. Both the actual boardand the diagram on p. 28 of the manual show a 13 x 14 x 13 x 14 layout.Even though they call out only 12 pin numbers on a side. How do we in-stall this part? Which lands does it get connecte
SonyFD555
VERTICAL COLLAPSE Picture would collapse vertically after warm-up. Tubedburned.
SonyD555
DISC DOES NOT SPIN When play button was pressed sled moved and hit limitswitch but spindle motor will not turn. Found coil L-504 was open. Thisproblem is not the first time.


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads