Dicas Reparação




Modelo - Chassis D180K


Pesquisa: D180K Enviar Dica Resolvida
Resultados 10
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonyD180K
WILL NOT PLAY - REPLACE Q414, P/N 8-729-903-10 No power to optical block.
SonyD180K
NO POWER AC/DC - RESOLDER Q451 Had no power with adaptor. Checked Q451 and found it to becold soldered.
SonyD180K
DEFECTIVE BACK LIGHT - REPLACE PL-901, P/N 1-518-585-11 The LED's behind the play mode, key mode and stop buttons arevery dim. Checked voltages on Q-901 and they were fine. Checked PL-901and voltages were off slightly. Disconnected PL-901 and LED's were fine.PL-901 was drawing too much current. Applies to
SonyD180K
LIGHTS DIM ON PLAY MODE, KEY MODE AND STOP BUTTONS Orange lights on Stop, Play mode and Key mode buttons are dim.Checked Q-901 and found it to be leaking. Also pertains to serial numbers696012 and 694526.
SonyD180K
NO PLAY Unit would not play discs. In the test mode no searchfunction occured. There was a reading of 1 volt (B+) on pin No. 38(IC-504).
SonyD180K
UNIT DOES NOT FOCUS, FLEX CABLE HAS OPEN CIRCUIT Unit does not focus (flex cable has open trace). Movement ofthe optical assembly puts stress on the flex cable causing it to break.This is the second unit with this problem.
SonyD180K
FLASHING LIGHTS - NO OPERATION X-601 was oscillating erratically causing erratic operation ofIC-504 PWM Driver.
SonyD180K
STATIC INSTEAD OF AUDIO Static instead of audio.
SonyD180K
HIGH PITCHED SQUEAL, MECHANICAL Unit manifested a high pitched squeal during play. The noiseappeared mechanical since it did not come through the line or headphoneoutputs.
SonyD180K
DEAD DCC-50 ADAPTOR Found the wires reversed inside the cigarette lighter plug.Causes no damage to the unit. Dealer replaced about three units (DCC-50)under warranty. -HQ COMMENTS: We have received the sample you sent in, and haveforwarded it to Tokyo. Tokyo found that t


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads