Dicas Reparação
Modelo - Chassis D160
Pesquisa: D160 Enviar Dica Resolvida
Resultados 12
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CPD1604S | CRT REPLACEMENT SUB# | The original part number 873857105 subs to 873857698. The newnumber comes with yoke for CPD1730. | ||
| Sony | CPD1604S | NO GREEN DUE TO COLD SOLDER ON R-535 | Unit was missing green color. Tracing back from IC502, Ifound that level was low at pin 2. However, due to errors in S/M thisshould be blue input to AMP. Further tests proved that outputs of IC501are switched in S/M as follows:P-11 is G out, not B out | ||
| Sony | CPD1604S | PICTURE IS UNSTABLE WHEN CHANGING FROM TEXT TO GRAPHICS MODE | |||
| Sony | CPD1604S | RECOMMENDED SCREEN CLEANER | |||
| Sony | CPD1604S | RECOMMENDED SCREEN CLEANER/USE (3-731-449-01) DRY SOFT CLOTH | |||
| Sony | CPD1604S | NO PICTURE/SQUEALING SOUND (BLOWS H-OUT WITH RGB PLUGGED IN) | |||
| Sony | CPD1604S | INTERMITTENTLY LOSES GREEN, COLD SOLDER ON R526 ON "B" BOARD | The monitor would intermittently lose green. | ||
| Sony | D160 | PART NUMBER FOR DIODE ACROSS DC INPUT | There is a diode across the DC input jack. The pattern onthe PCB is also cut. This looks like a factory mod. I assume this is forreverse polarity protection. This diode is defective and I need the partnumber to order a new one. I could not find any | ||
| Sony | D160 | DISC WON'T SPIN | Disc won't spin. Spindle motor only had 1.2 Ohms ofresistance. Normally, the spindle motor has about 12 Ohms of resistance. | ||
| Sony | D160 | FAILURE OF UNIT DUE TO USE OF IMPROPER POWER SUPPLY | Used power supply with reversed polarity (i.e. RadioShack etc.) usually burns D-804 and Q-404. Symptoms include: dead unit,spindle turns backward (due to Q-404 failure), sled to outer perimeter.IC-802 fails due to surge and kills 5V supply. The majorit | ||
| Sony | D160 | REPLACEMENT OPTICAL BLOCKS | Replacement blocks coming through with pin 3 and 4 solderedtogether on 12 pin flex connector. This is just a little drop of solderwhich can easily be overlooked and cause the block not to work wheninstalled. This also is true on other models. | ||
| Sony | D160 | TWO VERSIONS OF MD | Original production units employed a mech-deck that had screwsholding the MD cover in place. Later production units, do not. The MDcover is held in place with snap claws (as shown in service manual).Replacement parts from KC are of the new version. Is |