Dicas Reparação
Modelo - Chassis CPD1320
Pesquisa: CPD1320 Enviar Dica Resolvida
Resultados 8
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CPD1320 | DISTORTION LINES AT BOTTOM OF PIC OR VERTICAL JITTER | Customer complained of unstable bands of lighter lines anddensity about an inch off the bottom of picture. If you flex the Dboard at the heat sink for IC400 you will get varying degrees of loss ofvert lin and vert jitter. The only ground for several co | ||
| Sony | CPD1320 | AFTER 1 HOUR TURNS GREEN, REPLACE IC-001 B-BOARD | After unit was on for an hour, display was all green. | ||
| Sony | CPD1320 | PICTURE IS UNSTABLE WHEN CHANGING FROM TEXT TO GRAPHICS MODE | |||
| Sony | CPD1320 | EXCESSIVE GREEN BACKGROUND WHEN USED WITH A MAC | Customer complains about the picture being green but, whenconnected to the signal generator at the Service Center the picture is OK. -HQ COMMENTS: Most likely what is occurring is that because MAC PCsoutput both Sync On Green and Separate H and V sync, | ||
| Sony | CPD1320 | RECOMMENDED SCREEN CLEANER | |||
| Sony | CPD1320 | CURVATURE OF THE CRT | What is the curvature of the CRT? -HQ COMMENTS: The radius of curvature of the CRT is: Side to side R =660mm. Diagonally R = 1015mm. | ||
| Sony | CPD1320 | NO PICTURE | High voltage, no picture. Please refer to S/M supplementnumber 2. Pressure from the cabinet bottom is causing the plastic spine topush diode D-402 against pin 7 of IC-400. Also applies to serial number5000850.SOLUTION: Clip pin 7 of IC-400 to remove the | ||
| Sony | CPD1320 | DEAD UNIT | No picture. |