Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | CFS1035 | NO AUDIO IN TAPE MODE (RADIO O.K.) | In tape mode: Either no output or output on only one channel. | ||
Sony | CFS1035 | UNIT WILL NOT PLAY OUT ONE OF THE SPEAKERS - RESOLDER J303 | Unit will not play out of one of the speakers. Found phonejack J303 poorly soldered. | ||
Sony | CFS1040 | NO AUTO REVERSE - REALIGN LEVER (REF 118) | Deck will play one direction when you hit the reverse buttonto play other direction it gets stuck and will not reverse. I am the decktech and out of the decks I repair I see this problem 6 out of 20 decks(3%). | ||
Sony | CFS1040 | NO AUDIO OUTPUT ON TAPE - RESOLDER LEAF SWITCH S401 | Tape deck functions work properly, but no audio output andOpr/Batt indicator off switch terminals of S401 are cold soldered, causingS301-1 that supplies voltages to Pin 9 (Vcc) of IC303 (power amp) and D350(Opr/Batt indicator) to zero volt. | ||
Sony | CFS1030 | NO AUDIO - REPLACE Q304, P/N 8-729-177-32 | No audio output. | ||
Sony | CFS1030 | DOOR OPENS ON STOP INSTEAD OF EJECT. | #251 lever line breaks off under #203 lever, stop. #206slider (s), eject therefore selected when stop is pressed. | ||
Sony | CFS1040 | MECHANICAL NOISE FF/REW AND AUTO REV SHUTOFF | |||
Sony | CFS1040 | NO AUTO SHUTOFF AND/OR NO RECORD AFTER DIRECTION CHANGE | No record - button will not depress. Moving Ref#132 lever(erase N) or Ref#128 lever (erase R) will not help. Ref#228 spring fallsout of slider (FR) which causes no auto shutoff (continuous cycle only).The end connected to #229 slider (Mode A) falls out | ||
Sony | CFS1040 | INTERMITTENT OR NO FWD PLAY | Ref#119 gear (base), head becomes bent, therefore, Ref#117spring (head) torsion does not complete its cycle. Also, Ref#144 gear(NR) cam has insufficient motion to complete its cycle. | ||
Sony | CFS1020 | WRONG PART NUMBER LISTED IN MANUAL | Service manual for this unit lists motor as part number1-541-231-00. This motor is too big and interferes with cassette dooroperation. | ||
Sony | CFS10 | END OF TAPE SENSOR NOT ALIGNED | As tape moves in play mode - end of tape sensor is not alignedfully with width of tape causing uneven pressure and wrinkling of tape. -HQ COMMENTS: The crease in the tape is indeed caused by excessivepressure as well as uneven placement of the PU lever |