Dicas Reparação




Modelo - Chassis CFD767


Pesquisa: CFD767 Enviar Dica Resolvida
Resultados 7
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonyCFD767
MAIN BOARD FROM STOCK DIFFERS FROM UNIT The main board received from NPC is different from the one inunit. When installed and powered up, board smokes. We checked supplementsand corrections, found nothing regarding this problem.Sample board forwarded to NPC(partially modified by tech).
SonyCFD767
TAPE DECK BAD RECORD AND PLAYBACK Needed a new tape head. Page 83 of s/m shows the former typeof mech. Discovered the former head and its connector were never put inthe system and they do not exist. -HQ COMMENTS: I checked the discrepancy with KCP. The former head andconnector have not
SonyCFD767
"A" DECK TAP DOOR OPEN ON STOP INSTEAD OF EJECT #452 lever line breaks off under #408 lever, stop. #409slider (s), eject is therefore selected when stop is pressed.
SonyCFD767
LOW AUDIO ON CD - RESOLDER R782. Low audio on CD. Audio was good at IC707/pins 2 and 6.Found voltage at IC708/pins 3 and 5 to read 0.5V while it should have read3.4V.
SonyCFD767
SOUND CUTS OUT INTERMITTENTLY Sound cuts out intermittently and technician (Chad Tremble)found that the flex cable from terminal to cone is conductingintermittently. Suspected the defective flex cable. -HQ COMMENTS: I checked the speaker and I agree with your findings.There is a po
SonyCFD767
SQUEALS LOUDLY WHEN YOU INCREASE VOLUME - S/M SUPPLEMENT In all modes (CD, Tape, Radio), unit squeals loudly as youincrease volume. Found a factory modification which is not detailed inthe service manual. It has been done to the mic mix jack to mix amp area.
SonyCFD767
CD DRAWER WILL NOT OPEN The CD drawer will not open even after the 10 second delay.I found that one or both of the wires (Ref. No. 615 and 616) that connectthe inductors (L-701 and L-702) to the translation board (Ref. No. 651)are not connected. Closer examination showed that


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads