Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | CFD10 | CD WILL WORK SOME TIMES - RESOLDER IC703 | Cd will work intermittently, IC703 has cold solder or nosolder. Unit will focus but not spin sending the optics on the outposition. | ||
Sony | CFD10 | CD WON'T WORK | Replaced melted cd lid, melted by high power lamp? and foundref 113 magnet holder shrunken also. Replaced ref 113 part number338697101 listed in manual and it won't fit properly, still too short. | ||
Sony | CFD10/12 | INCORRECT PART NUMBER FOR OPTICS: CHECK CORRECTION #1 | The part number listed for the optic device is incorrect.The part number listed is 8-548-137-11 for model CFD12. This info is onpage 37, Ref 405. For model CFD10 this info is on pg 64 Ref 405.SOLUTION: The correct part number for the optic device is 8 | ||
Sony | CFD10 | NO AC POWER: REPLACE INLET JACK P/N 1-540-009-11 | Switch inside inlet jack is defective. The switch gets stuckin the battery power position and will not accept the power cord. | ||
Sony | CFD10 | SPEAKER RATTLES/DISTORTS - REPLACE SPEAKER (1-504-237-21). | Speaker rattles during playback of all sources of audio. | ||
Sony | CFD10 | NO MECHANICAL MOTION (TAPE DECK) ON MALAYSIA MODEL | In order for the tape deck to work, S601 (Motor on/off sw)should be properly triggered by lever (MD) (Ref. #66). But because of agap between the lever and switch, S601 will not activate causing nomechanical motion. | ||
Sony | CFD10 | Q303 OVER HEATING | Unit works OK on all modes for two days. However Q303, theregulator transistor seems to be overheating. | ||
Sony | CFD10 | NO CD OPERATION | CD player will not play or plays int. Found optic cables tooshort from optic to main PCB causing too much tension when optic is inhome position resulting in int. or no reading of TOC. |