Dicas Reparação
Modelo - Chassis CDXR79
Pesquisa: CDXR79 Enviar Dica Resolvida
Resultados 28
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CDXR79 | SKIPPING WHEN OUTER TRACKS ARE PLAYED | The customer may complain that skipping occurs when outertracks of discs are played. This may occur if the mechanism sub-chassisis bent, which makes it more difficult to maintain proper focus at theouter portions of discs. | ||
| Sony | CDXR79 | SWITCHES FROM TUNER TO CD AT RANDOM (REPLACE SW622) | While playing the radio, the unit reverts to CD operation evenif no CD has been inserted. | ||
| Sony | CDXR79 | EJECTS DISC PREMATURELY (UNIT MOUNTED AT 45 DEGREE ANGLE) | This unit is mounted at an approximately 45 degree angle in aconsole on top of the transmission. Intermittently it will eject or nottake a disc. Are there restrictions on the angle of installation? Wouldheat from the transmission cause the unit to eje | ||
| Sony | CDXR79 | AM SEEKS IN 9KHZ STEPS | AM seeks in 9kHz steps. Is there a combination of buttons todepress to convert to 10kHz USA mode as on some other models? | ||
| Sony | CDXR79 | SERVICE MANUAL ADJUSTMENT SECTION ERRORS | The adjustment section of the manual has several errors. Onpage 11, shouldn't spindle height be closer to .95mm than .95cm? On pages12 and 13, the diagrams show the scope connected to ground. I believethe proper reference is Vc (2.5V) for any RF amp a | ||
| Sony | CDXR79 | WILL NOT EJECT | Ratcheting noise when unit is trying to eject. | ||
| Sony | CDXR79 | SKIPS | Skips on all discs. Found spindle motor did not have suffi-cent torque. | ||
| Sony | CDXR79 | INCORRECT PART NUMBER - L403 | The part number listed in the S/M does not come up as valid inthe KCP parts system. What is the correct P/N? -HQ COMMENTS: Tokyo Fax TX-USA91086. Correct P/N for this inductor is1-410-524-41. Refer to Car (CSA-14) Service Bulletin No. 204. | ||
| Sony | CDXR79 | SKIPS DURING TRACKS 3-5 | Burbank informed me that he has had complaints where the unitwill skip or stop on track 3 or 5. He installs a piece of plasticbeneath the metal clip which holds the ribbon cable (larger one) close tothe FOP body to extend the ribbon connector. He says | ||
| Sony | CDXR79 | DISPLAY ILLUMINATION IS WEAK | Illumination is really weak and/or remote line out does notwork. This problem occurs quite frequently. | ||
| Sony | CDXR79 | CD STOPS IN THE MIDDLE TRACKS | Many CDX-R77's, R79's, 7540's and 7580's have CD stuck in MDduring 3 to 5 tracks. The problem is when FOP moved to the middle of theguide shaft the FOP's flexible PCB touch gear (B) Lock (Ref. No. 404).Then unit shuts off. | ||
| Sony | CDXR79 | NO FUNCTIONS, ALL LCD SEGMENTS ILLLUMINATED CONSTANTLY | Unit sent to Dallas SSC from authorized servicer who wasunable to cure a disc loading problem. When checked by Dallas technician,the unit was inoperative except for LCD segments being lit constantly. Ifthe deck is disconnected from the unit all other f | ||
| Sony | CDXR79 | QUICK CHECK OF AMP REMOTE LINE | Remote line testing can be made easier. | ||
| Sony | CDXR79 | WILL NOT LOAD DISC - ROLLER SLIPPING ON SHAFT | The disc will not be pulled into the unit. It may also not beejected. The disc is engaged with the roller, but the roller is slippingon the shaft. | ||
| Sony | CDXR79 | CD SKIPS AND FREEZES UP ON CERTAIN TRACKS | CD plays beginning of the first track and then freezesup at the middle and the end of the CD. |