Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | CDXC590 | CD DOES NOT PLAY, DISPLAY READS E-04 | The LCD display of the unit reads E-04. This may be caused bythe CD making contact with the chucking arm (ref# 122). This may cause theCD not to spin and eventually displaying an error message. | ||
Sony | CDXC590 | OPTICAL PICKUP/SERVO BOARD INCOMPATIBILITY (KSS-410A/313A) | The unit came in for service with type KSS-313A opticalpickup, which was defective. The type shown in the service manual isKSS-410A, which was ordered from NPC and installed in the unit, but thispickup did not work in the customer's unit. | ||
Sony | CDXC590 | SKIPS (FOUND DAMPER DISLODGED FROM DAMPER SHAFT) | The unit skips. | ||
Sony | CDXC590 | WOULD NOT READ DISCS(FOUND FOREIGN MATERIAL IN MECHANISM) | The unit would not read the discs (the discs would not evenspin). | ||
Sony | CDXC590 | DEAD (FOUND YELLOW WIRE POORLY SOLDERED IN HARNESS FILTER) | The unit was dead. | ||
Sony | CDXC590 | POOR FM RECEPTION (FOUND CRACKED SOLDER ON ANT. JACK CNJ502) | The unit had poor FM reception. | ||
Sony | CDXC590 | NO AUDIO (FOUND ELECTRNOC VOLUME CONTROL IC301 DEFECTIVE) | The unit had no audio. | ||
Sony | CDXC590 | NO TUNER FUCNTIONS (FOUND OPEN TRACE AT CATHODE END OF D310) | There were no tuner functions. | ||
Sony | CDXC590 | DISPLAY FAILURES (MISSING SEGMENTS, CRACKED LCD, ETC.) | Various display failures have been noted, such as missingsegments, cracked LCD, segments always illuminated, etc. | ||
Sony | CDXC590 | CAN'T TURN UNIT OFF WHEN NOSE PIECE REMOVED (D901 WAS BAD) | Unit would not turn off when nose piece removed. Fewsegments of bar graph did not turn off. All other functions operatedcorrectly. | ||
Sony | CDXC590 | NO AUDIO (FOUND AUDIO AMP IC304 DEFECTIVE) | No audio. Found audio amp IC 304 defective. -HQ COMMENTS: Tokyo has analyzed samples we sent them and havedetermined that the defects are ususally caused by excessive reversevoltage being applied to the IC, probably by the power antenna relayturning of | ||
Sony | CDXC590 | REMOVING KEYSWITCHES (USE PYRO-PEN JR. ON SETTING # 1) | The keyswitches may be difficult to remove without damagingthe PCB. | ||
Sony | CDXC590 | KEYSWITCHES FAIL | The keyswitches fail. It is most often the SELECT key butcould be any key. Sometimes there are more than 1 bad switch on the samefaceplate. -HQ COMMENTS: The QA group in Tokyo has been notified and samples havebeen sent to them. An improved switch ha |