Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | CDX5460 | NO FUNCTIONS (REPLACE D526, P/N 8-719-921-59) | The unit had no functions when the buttons were pressed. Pin#1 of IC501 had 0V. Found D526 shorted. | ||
Sony | CDX5460 | DISC CHUCKING NOT COMPLETED DURING LOADING, GEAR NOISE HEARD | The unit will pull in the disc, but will not chuck the disc.Gear noise can be heard while unit should be chucking the disc. | ||
Sony | CDX5460 | FACEPLATE WARNING BEEP DOES NOT WORK | When face plate was left on and ignition turned off, unitwould not beep. Check pins 41 and 46 on IC501, found 41 low and 46 high,when ignition was turned off. | ||
Sony | CDX5460 | WILL NOT LOAD CD/GRINDING NOISE (STRAIGHTEN REF. # 10) | When CD is loaded into unit, Load will flash for about fiveseconds, and there will be a grinding noise before CD is ejected. | ||
Sony | CDX5460 | UNIT STAYS IN TEST MODE (REPLACE IC501, P/N 8-759-167-49) | When powered up, display of unit goes through test modefunction. Reset has same effect. When AM, FM or CD is selected, unitgoes through corresponding test mode function. | ||
Sony | CDX5460 | WILL NOT LOAD CD (REPLACE SW1, P/N 1-571-754-31) | Found SW1 broken. Replaced switch and unit workednormally. | ||
Sony | CDX5460 | DISC JAMS DURING LOADING (RE-SEAT ST LEVER, REF. 136) | When CD is inserted into unit, it goes about halfway in andthen stops. The unit then begins to make clicking/grinding noises beforeejecting CD. | ||
Sony | CDX5460 | EXPLANATION OF ERROR CODES NOT SHOWN IN SERVICE MANUAL | Is there a list of the error codes available for the abovemodel? How about other models? -HQ COMMENTS: The list of error codes for this model is limited, andunfortunately the explanations are not very descriptive. The only errorcodes we know about ar | ||
Sony | CDX5460 | AUDIO CUTS OUT (REPLACE IC503, P/N 8-759-160-98) | IC503 heats up and loses 8v output, which causes the audio tocut out. |