Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | CDPC205 | AUDIO TOO FAST - IC301 DEFECTIVE | Unit played disc but audio was too fast (like a 33rpm recordplaying @ 78rpm). X301 was @ normal freq., 16.9 mhz. | ||
Sony | CDPC205 | PART NUMBER FOR BRACKET (PRESS PULLEY) SAME AS CDP211 | In the service manual there is no reference number and no partnumber for the press pulley bracket. | ||
Sony | CDPC205 | LEGS OF POWER TRANSFORMER DO NOT MATCH HOLES ON PCB | The power transformers supplied by NPC (p/n 1-449-954-11) havelegs which do not line up with the holes on the power PCB. -HQ COMMENTS: Tokyo has advised that the transformer can be adapted tothe power board by trimming the two leads that do not match th | ||
Sony | CDPC205 | INTERMITTENT SCRAPING NOISE | Magnet assembly (909) rubs against the chucking arm (67)intermittently. Have seen this five times. | ||
Sony | CDPC205 | DISK TABLE DOESN'T POSITION PROPERLY | Disk tray does not position properly over pick-up. Sometimesit stops before then jerks its way in position. Found the plastic pivotshaft was worn on bottom side of disk table which has plastic burrs whereit rubs against the bracket (ref.58). | ||
Sony | CDPC205 | TRAY DOES NOT STOP AT CENTER OF PICKUP | Tech in San Diego showed me that when you go to the next diskthe tray would stop early and then at times would jerk its way to centerof laser base assembly. The problem appears to be either a warped tray orcabinet assembly. Sometimes the problem is int | ||
Sony | CDPC205 | INTERMITTENT SPINDLE MOTOR START | Spindle motor has to be given a little push in order to get upto speed. | ||
Sony | CDPC205 | WRONG PART FOR DISK TABLE | When she ordered Reference No. 52, (2 hole type) and receiveddifferent type of table assembly (looks like CDP-C400 one hole typetable). This is according to Cathy in Pittsburgh. I looked up PMI and<-28> on display (national backorder). | ||
Sony | CDPC205 | INTERMITTENT OPERATION | Unpredictable problem sometimes it has run away spindle motor.Sometimes it will not do anything. | ||
Sony | CDPC205 | DISK TRAY PLAY | Disk tray has too much play allowing chucking pulley to scrapeagainst chucking arm. | ||
Sony | CDPC205 | DAMAGED LOADING GEAR | Unit will either not open and close properly or the drawerwill close, open slightly and then reclose. | ||
Sony | CDPC205 | WILL NOT TRACK JUMP TO LAST TRACK ON CD | Unit would read T.O.C. and play ok but when I would try tojump to last track the player would not jump to last track and acted likeit did not know that there was a last track. | ||
Sony | CDPC205 | INCORRECT PART NUMBER - SPINDLE MOTOR | Part number for spindle motor (M-101) is incorrectly listed inthe service manual. |