Dicas Reparação
Modelo - Chassis CDPC201
Pesquisa: CDPC201 Enviar Dica Resolvida
Resultados 8
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CDPC201 | DISC TABLE DOES NOT OPEN - REPLACED IC401 RESTORED OPERATION | Disc table does not come out. Disc chucks five time and stops.When I pressed DISC SKIP or DISC TABLE OPEN, unit did not respond. -SOULUTION: Found the main cam gear had a dent in the rim. I replacedit, but this DID NOT solve the problem. I then replaced | ||
| Sony | CDPC201 | PART NUMBER FOR BRACKET (PRESS PULLEY) SAME AS CDP211 | In the service manual there is no reference number and no partnumber for the press pulley bracket. | ||
| Sony | CDPC201 | LEGS OF POWER TRANSFORMER DO NOT MATCH HOLES ON PCB | The power transformers supplied by NPC (p/n 1-449-954-11) havelegs which do not line up with the holes on the power PCB. -HQ COMMENTS: Tokyo has advised that the transformer can be adapted tothe power board by trimming the two leads that do not match th | ||
| Sony | CDPC201 | INTERMITTENT SCRAPING NOISE | Magnet assembly (909) rubs against the chucking arm (67)intermittently. Have seen this at least five times. | ||
| Sony | CDPC201 | NEW SPINDLE MOTORS ARE BENT | Vertical jitter on RF waveform (eye pattern) after spindlemotor replacement. This is caused by a bent spindle shaft. There is nopacking material to protect the spindle shaft. Out of the last ten motorsreplaced, 6 were noticeably bent but could be used | ||
| Sony | CDPC201 | PROBLEMS WITH LOADING DISC | Unit(s) won't load some discs and chucking arm is defective.Is there any part number for the arm which shows Not Supplied? -HQ COMMENTS: Tokyo fax reply A910519 and A910520: P/N is A-4604-241-A.This part is currently not registered in KCP. | ||
| Sony | CDPC201 | DISC TURNTABLE SPINNING WHEN DOOR OPENS | Disctable keeps spinning around when door is open. | ||
| Sony | CDPC201 | INCORRECT PART NUMBER - SPINDLE MOTOR | Part number for spindle motor (M-101) is incorrectly listed inthe service manual. |