Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | CDPC100 | CONTINUOUSLY TRIES TO EJECT DISC (REPLACE D601) | Even with no disc in unit, it continued in eject cycle. Thiswas due to an open disc detect diode. | ||
Sony | CDPC10 | THE UNIT LOCKS UP AFTER PLAYING A DISC, IC-209 DEFECTIVE | After unit finishes disc, it locks up, and only turning itOFF and ON again will restore manual play. Following the chart from themanual I figured out that motor M-3 fails to work intermittently when itwas supposed to position the played disc in front of | ||
Sony | CDPC10 | UPON POWER UP, ELEVATOR ASSEMBLY MOVES TO TOP OF UNIT | When AC is removed from unit, the disc that is playing staysloaded on optics. When power is restored, the disc chassis assemblymoves up to top of unit and stops. Found defective S-401. | ||
Sony | CDPC100 | M-602 WRONG PART SUPPLIED | Reference service manual correction No. 1. The motor fromthese two unit is FF-280SA. The motor supplied under the above partnumber is FF-130SH. Smaller different shaft, different spacing of pinsfor PCB mounting. Also pertains to serial number 810448. | ||
Sony | CDPC100 | UNIT WILL NOT EJECT | Unit will not sense that elevator is at height to play disc,and the unit jams. Put magazine in unit accepts disc and elevator goes tolowest (play) position and jams. | ||
Sony | CDPC100 | DISC WILL NOT GO INTO MAGAZINE | Disc will not go back into magazine in certain slots. It jamshalf way in. I detected some wear and scratches on the metal springwithin the magazine. This causes the disc to stick and not go backinto the cartridge. | ||
Sony | CDPC100 | DISC JAMMED INSIDE | Disc jammed when going into magazine after play. | ||
Sony | CDPC100 | DISC SPINS BACKWARDS | Disc would spin backwards. Reversed motor leads and unitwould play ok until IC-202 warmed up then spindle motor would again runbackwards. | ||
Sony | CDPC10 | INCORRECT PART - GLASS PANEL COVERING DISPLAY | Servicer ordered above part number and received that numberbut it was the incorrect part. Enclosed is not the part we ordered.Replacement part, which is incorrect, is enclosed. Please adviseKansas City Parts Center. -HQ COMMENTS: The glass panel for t | ||
Sony | CDPC10 | NO RESET BUTTON | On page 5 of the service manual, in both the laser checkprocedure and the troubleshooting flow chart, there is mention of a resetbutton, while none exists in the unit. -HQ COMMENTS: Thanks for the info. There is no reset button as younoted. To reset t | ||
Sony | CDPC10 | UNIT JAMS AFTER REPAIR | Unit jammed after a minor repair - erratic operation would notplay disc. Totally unrelated to original problem. | ||
Sony | CDPC100 | XA10B SCRATCHES DISC | XA10B would scratch disc because of a piece of wire inbeddedinto one of the magazine leaves. The wire stuck out about 1/16th of aninch. | ||
Sony | CDPC10 | DEAD UNIT; PORT EXPANDER IC212 | Unit was inoperative when cartridge inserted. M-2 did notoperate. Found no data on pins 17, 18, 19. Lifted these pins and datawas being supplied. | ||
Sony | CDPC10 | GEAR GETS DAMAGED | Gear referred as item No. 321 on page 44 of service manual isstripping probably from excessive stress when customer uses certain thick-er audio discs. Servicer reported failure of several units. | ||
Sony | CDPC10 | DEFECTIVE OPTICAL BLOCK | Won't play. |