Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | CDP510 | HIGH NOISE DURING PLAY | High pitch noise through audio when playing. The noise couldbe seen coming out of IC-202 (D/A converter), but not going into the D/A.I replaced the D/A and had the same problem. I could also see the noisecoming out the Ram. | ||
Sony | CDP510 | DISC DOESN'T TURN OR TURNS SLOW WITH NOISE | Disc turntable is pushed all the way down. I've seen a dozenunits with the same problem. | ||
Sony | CDP510 | IRREGULAR DISC ROTATION | Unit would not play discs. After pressing PLAY, disc wouldspin with loud, irregular thumping noise. | ||
Sony | CDP510 | ROLLER GUIDE FOR CHUCKING ARM ASSY COMES OFF | Roller guide for chucking arm assy comes off. This roller isbrown one. | ||
Sony | CDP510 | SPINDLE ASSY SLIPS DOWN | Caused disc's to be damaged. Found spindle assy had slippeddown motor shaft. This was a new unit that failed out of the box. -HQ COMMENTS: Confirm to monitor this and similar models. We willhave stock checked when we can confirm enough additional cas | ||
Sony | CDP510 | DISC OVERRUNS OR OVERRUNS REVERSELY | Disc overruns because the optical block jams at the innermostlimit. Same as CDP-35/55/65/70/203 etc. | ||
Sony | CDP510 | SKIPPING ON FIRST TRACK | Stock unit. Skipping on first track. Found sled drive vol-tage going to 1.8V-2.0V before the sled would move. Loosened sled motorholding screw and repositioned worm gear to open meshing with sled gear.Now drive voltage goes to 0.6V and sled moves smoo | ||
Sony | CDP510 | DISC WILL NOT CLAMP AFTER LOADING | Breakage of chuck arm and loss of chuck arm roller. | ||
Sony | CDP510 | CHUCKING ARM MOUNT BROKEN | Chucking arm mount broken during shipping. See attached. -HQ COMMENTS: We've seen a couple broken supports. We will monitorthis in the field. If you see more, please send serial numbers as well. |