Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | CDP110 | INACCURATE AND MISSING PROCEDURE IN SECTION 2 OF CDP110 S/M | 1. RF PLL freq. adj.: serial/Parallel TP must be graded forthis procedure to work. 2. No. 6 should read 4.2818mHz instead of4.3218mHz. -HQ COMMENTS: You are correct. For future cases please refer to theCDP Alignment Manual that Rick Heal wrote. Page | ||
Sony | CDP110 | UNIT MAY NOT FOCUS OR MAY NOT TRACK | Unit may not focus or may not track. Power up unit andvisually view lens. If lens is off center or does not seem to have fullfocus travel, the problem is IC-2. When this condition occurs, it wouldbe normal to suspect the driver amps (IC6 and IC7). Ho | ||
Sony | CDP110 | SPINDLE MOTOR RUNS BACKWARDS | Spindle motor runs backwards. Unit was serviced at a dealerwhere the spindle motor had been replaced. | ||
Sony | CDP110 | MAKES NOISE AND DOOR WILL NOT STAY CLOSED | Unit makes noise and door will not stay closed. | ||
Sony | CDP110 | IC3 FAILURE | Four units with distorted audio of varying degrees - somequite severe. Found IC303 (CXD1135Q) defective. This was after theRAM chip was changed on two of the units. | ||
Sony | CDP110 | ROLLER GUIDE FOR CHUCKING ARM ASSY COMES OFF | Roller guide for chucking arm assy comes off. This rolleris a brown one. |