Dicas Reparação
Modelo - Chassis CCDV9
Pesquisa: CCDV9 Enviar Dica Resolvida
Resultados 60
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CCDV9 | EXCESS BRIGHTNESS AND NEGATIVE IMAGE IN EVF / NEW BOARDS | Excess brightness and negative image in EVF after installedthe new MCB ordered from NPC. Found resistors R908 R923 values reversed. -SOLUTION :Reinstalled R908/R923. EVF returned to normal. | ||
| Sony | CCDV99 | SPEED CHANGES FROM SP TO LP DURING SCAN (C837) | Refer to FPR O3609. Although replacing C833 effects a cure,additionaly replacing C837 further reduces the noise and enhances the longterm performance of this unit. | ||
| Sony | CCDV99 | AUDIO OUT JACK CUTS OUT/CHECK INSULATION ON PJ-12 BOARD | Audio out jack would be intermittant. Trace problem to flatcable which lays across PJ-12 board. Pins on audio jack pierced throughinsulation of cable. | ||
| Sony | CCDV99 | NO COLOR RECORDED/L603 (VI-55) OPEN | No color recorded on tape by this unit. Playback good of othertapes. | ||
| Sony | CCDV99 | VERTICAL BARS IN VIDEO CAMERA MODE/REPLACE C237 | In camera mode, the unit displays vertical bars after about 5minutes of warming up. C237(22uf/35V) was leaky, also physically spilledfluid on circuit board. | ||
| Sony | CCDV9 | DEAD/REPLACE F952 AND C619 | Unit dead, blown fuse F952. | ||
| Sony | CCDV99 | DISTORTED PICTURE DURING CUE AND REVIEW/CHANGE R873 TO 3.9K | Unit produced a good picture in playback with normal and Hi-8tapes. No problems with pre-recorded tapes either. The only problemencountered was the unit would switch to LP during cue and review. An FPRThis signal feeds a SP/LP detection circuit on th | ||
| Sony | CCDV99 | ZOOM MOTOR RUNS ON ITS OWN- INTERMITTENTLY/CHECK IC-453 | There was intermittent movement of the zoom ring to wide angleside without touching the zoom switch. Upon disassembly, the problemusually clears up or becomes more intermittent. | ||
| Sony | CCDV99 | DISTORTED PICTURE ON PLAYBACK | The unit produced no picture in playback or EE mode. Thecamera continuously produced a gray screen only. I traced signal to pins1 of IC403 and IC404. The signal appeared at both inputs but would outputsync only at pin 7. Q491 is used as a sync to det | ||
| Sony | CCDV99 | INOPERATIVE UNIT | Unit came in inoperative. F-62 on the FU-66 board wasoverdiscipated. Replacement did not solve problem. | ||
| Sony | CCDV99 | PART NUMBER FOR DRUM BASE ASSY/X36864825 | There is no part number for the drum base assy in the servicemanual. | ||
| Sony | CCDV99 | SCANS AT LP SPEED WITH SP TAPE | Plays SP and LP tapes correctly but when using CUE/REV with SPtape the capstan servo will change to LP scan speed after one or two sec-onds. In Play, Still, and Slow Motion the picture is good. Confirmedtape path alignment is good. RF at test points o | ||
| Sony | CCDV99 | CAPSTAN SERVO CHANGES TO LP SPEED AFTER ONE OR TWO SECONDS | In CUE/Review mode with an SP tape inside, the capstan servowill change to LP speed after one or two seconds. The data screen con-firms this speed change. Customer is upset. -HQ COMMENTS: The cause seems to be with the PB SP/LP line on pin 59 ofIC-501 | ||
| Sony | CCDV99 | INTERMITTENT NO COLOR | E-E color looks ok but on playback color intermittently cutsout. This is very intermittent and difficult to reproduce. | ||
| Sony | CCDV99 | PART NUMBER FOR REC PROOF SWITCH TAPE SELECT/157229811 | There is no part number listed for the REC proof switch onthis model. What is the part number? |