Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | CCDV5000 | DIST AUDIO FIRST APPROX 10 SEC AFT CAM ON/RPL C378, PC52 BD | Distorted and low audio for first approx 10 seconds afterturning camera on. Has to be off for several hours in order toduplicate. | ||
Sony | CCDV5000 | NEW MIC JACK PART DIFFERENT INTERNALLY THAN ORIGINAL/JUMPER | Standardized Replacement Dual Mic Jack p/n 150779721 has different internal switching from original jack. Because pins 5 and 6 must be cut off to fit board, the Mic audio is lost. | ||
Sony | CCDV5000 | HORIZONAL BAND LINES IN PLAYBACK/RESLD PIN1, CN605, DI-21 BD | Unit had intermittent problems in playback: 1.horizontal bands of incorrect color, 2.colors changing, 3.no video output. | ||
Sony | CCDV5000 | INTERMITTENT COLOR ON RECORDING/ REPLACE C630 | Intermittently no color on recordings, E-E and playback are OK. Found defective filter capacitor C630 in chroma processor. | ||
Sony | CCDV5000 | UNIT SHUTS DOWN WHEN USING BATTERY/REPLACE IC103 | Unit ran fine on AC adaptor but would not ooperate withbattery. Tech was not able to perform battery down adjustment, no matterwhere set unit shut down at 6.3 volts. Battery sense line at themicroprocessor was changing when RV001 was adjusted at pin 4 | ||
Sony | CCDV5000 | POOR VIDEO IN FORWARD SEARCH (TEARING): REF 304 LEFT COASTER | Unit had excessive hitches in forward play, forward search hadan unusable picture. | ||
Sony | CCDV5000 | BLOWS FUSES, CAPSTAN FLEX RUBS THROUGH | Unit had F603 open. Found that FU70 board was rubbing thecapstan motor flex cable. There was no FU insulating plate. | ||
Sony | CCDV5000 | UNIT DEAD NO LCD | FOUND Q106 OPEN, So even with ever 5V units MICRO (IC101) DIDNOT DETECT BATTERY IN. -HQ COMMENTS: IC103 is the voltage regulator IC. The voltage detectorIC104/IC105 then commands Q106 to switch between Lithium or Batteryvoltage. | ||
Sony | CCDV5 | LENS NEEDS HELP TURNING IN AUTO FOCUS. | Lens did not have enough torque in auto focus. Focus was fineif you helped it turn. Did not want to replace lens for this problem. | ||
Sony | CCDV5000 | TIPS FOR PIX NOISE | I have noticed, on these units, if you see white snownoise in the pix, then usually the head is defective. If, however, you seedark dropouts or streaks in the pix, you can usually expect both the headand RP amp to be defective. In either case, remember | ||
Sony | CCDV5000 | NO EJECT OR OTHER FUNCTIONS. TAPE JAM/REPOSITION TENSION ARM | Reference FPR #L0970. Tension arm jumped track, tape onwrong side, will not unthread. Repositioning tension arm allows unitto work OK. Problem then cannot be duplicated. This has been seen onseveral units. Seems to occur the first time a new tape i | ||
Sony | CCDV5 | INTERMITTENT RAINBOW IN VIDEO/LAP HEADS | Customer complained of glitches and distortion in pix. Atfirst servicer found loose guides and also adj tape path. Then he noticedintermittent rainbows and a vertical bar on self-recorded tapes. He re-soldered connections on MR-8 board and unit seemed | ||
Sony | CCDV5000 | NO VIDEO | No EE or PB video. Using the CCDV5000 troubleshooting guide,we traced the signal up to pin 16 of the HD8 HIC board, but a very weakone coming out of pin 20. | ||
Sony | CCDV5000 | INTERMITTENT DIGITAL EFFECTS/CHECK CONNECTION CN603 | Picture on EE and PB was OK, but digital effects did notwork. | ||
Sony | CCDV5 | IC651 P/N; REFERENCE SB 12/RE-INSTALL ORIGINAL PART | Per s/b 12---used 8-759-945-17. Unit would not work afterreplacement. |