Dicas Reparação
Modelo - Chassis CCDV3
Pesquisa: CCDV3 Enviar Dica Resolvida
Resultados 35
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CCDV3 | NO CAMERA E/E OR RECORD PICTURE | No camera picture in EE or RECORD modes. | ||
| Sony | CCDV3 | NUMBER '5' SCREW ON R CABINET (ITEM 21) | Number 5 screw on R cabinet, many times is very difficult tobe removed due to the glue used. The cabinet may be damaged in theeffort to remove the screw. | ||
| Sony | CCDV3 | NO COLOR IN PICTURE | No color in picture. | ||
| Sony | CCDV3 | ADJUSTMENT FOR BATTERY FAILURE | Procedure in manual will not work. Unit will not evenoperate. | ||
| Sony | CCDV3 | PART NUMBER FOR MICROPHONE WINDSCREEN | Service manual does not show P/N. Please advise. -HQ COMMENTS: Part number is 3-716-448-01. A service bulletin will beissued shortly. | ||
| Sony | CCDV3 | NEED PART NUMBERS FOR FLAT CABLES (MV-11 BD TO SS-70 BD) | P/N of (2) flat cables from MV-11 board to SS-70 board(see Page 177). -HQ COMMENTS: The part numbers are on Page 185 of S/M.18 Pin 1-558-895-1122 Pin 1-558-896-11 | ||
| Sony | CCDV3 | PIGGYBACK IC | CCD-V3 has piggyback IC on IC301. What do you do to changeIC? -HQ COMMENTS: First 3000 units in production have this piggyback IC. Wewill issue a S/B shortly on this. | ||
| Sony | CCDV3 | INTERMITTENT NO PICTURE | Intermittent no picture. Sample forwarded. | ||
| Sony | CCDV3 | NO RASTER - VIEWFINDER | No picture in the viewfinder, problem traced to the connectorCN207 on the MV-11 board. Resoldered all 8 pins, unit came on. You couldnot see anything wrong. This is the second unit I have come across withthe same problem, just soldering the pins unit | ||
| Sony | CCDV3 | SOFTWARE JAM | Take-up reel will not work properly causing slacks on tape,eats tape and will not eject. | ||
| Sony | CCDV3 | AUTOFOCUS MOTOR NOISE | Auto focus motor noise. | ||
| Sony | CCDV3 | INTERMITTENT NO COLOR IN CAMERA MODE | Intermittent no color in camera mode. Replaced X721 on theVC-20 board that changed frequency from 28.636 MHz to 28.682 MHz.Defective sample attached. -HQ COMMENTS: A service bulletin will be issued shortly regardinga circuit change. | ||
| Sony | CCDV3 | NO CAMERA VIDEO - PLAYBACK OK | No video from camera, playback OK. Camera video looks as ifhoriz. sync. freq. is off, but flashes bright sometimes. Found X721on VC-20 board not oscillating. | ||
| Sony | CCDV3 | NO EJECT | Unit would not go into the eject mode. | ||
| Sony | CCDV3 | DISASSEMBLY INSTRUCTIONS INCORRECT | See Procedure 2-16 Separation of Camera Assembly and VTRAssembly. Balloon #5 not called out. See attached sheet (Page 34 of SVCManual). -HQ COMMENTS: Balloon number 5 should be to the screw just to theupper left of CN451 (Balloon No. 1). A S/B will b |