Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | CCDV3 | CAMERA SHUTS DOWN AT POWER ON / SHORTED CAP C884 | VTR works fine, but when camera switch on camera shuts down.Found shorted cap on 5V line on VC22. | ||
Sony | CCDV3 | WILL NOT PLAY, UNIT GOES INTO DEW EJECT/REPLACE C424 | Found RF switch pulse at ZVP-P instead of 4.2v per manual.Traced problem to 4.2v regulated out of AFM process IC (IC401). Line wasshorted to ground. | ||
Sony | CCDV3 | IRIS CLOSED NO PICTURE | No picture E-E from camera. Open iris and picture appeared.IA-1 board was replaced and iris was replaced. All pulses and voltageswere correct at the IA-1 board. | ||
Sony | CCDV3 | INTERMITTENT LOSS OF POWER | Intermittent loss of power. | ||
Sony | CCDV3 | RECORDING NOISE IN AUDIO | When on Record, noise similar to motor noise was recorded withaudio. | ||
Sony | CCDV3 | CCD-V3 LENS HOOD | Is there a repair kit for the CCD-V3 lens hood? -HQ COMMENTS: No there is no repair kit for this. | ||
Sony | CCDV3 | NO REW, VIEWFINDER BROKEN | Unit would start to rewind but shutdown in 2.3 seconds. | ||
Sony | CCDV3 | PART NUMBER FOR IRIS BLOCK | Diagram for page 178 of service manual attached. Iris sticksand motor is ok. Is there a part number for the iris block? -HQ COMMENTS: This part will be available shortly. | ||
Sony | CCDV3 | NO CAMERA LUMINANCE | No luminance coming from camera section. Pin 36 of IC-801had no luminance signal, all DC voltages were correct and all signals toIC-801 were present - YH, B-Y, R-4 and YL-YH. Changed IC-801 still noluminance. | ||
Sony | CCDV3 | COMPONENTS ON (SS-70) BOARD DO NOT MATCH SCHEMATIC | There is a descrete component diode between R-328 and C-321 onthe (SS-70) board. The board revision numbered is A-16. Does the diodebelong there? -HQ COMMENTS: Tokyo said the -14 boards had descrete diode but the -16boards should not have one. | ||
Sony | CCDV3 | OPERATION MANUAL ERROR/PAGE 154/TABLE 7-5 | On table 7-5, page 154 correct the columns headings to readfrom left to right: K00 (IC301 (13) ) K01 (IC301 (14) ) K02 (IC301(15). Also change REW to FF and FF to REW. Do not change the Sw. Ref.Nos. - they are printed in the correct location. | ||
Sony | CCDV3 | SERVICE MANUAL ERROR | For proper interpretation of which switch is fast forward orrewind, the arrow drawn above S353 should be reversed on page 117. -HQ COMMENTS: We will publish a service bulletin on this. | ||
Sony | CCDV3 | NO PICTURE IN VIEWFINDER | The unit had no picture in the viewfinder, all other functionsworked fine. | ||
Sony | CCDV3 | NO POWER UP | Unit would not power up, found 5 volts not getting throughwindings of drum assembly. Open windings in upper drum. | ||
Sony | CCDV3 | SHUT DOWN | Unit would load and rewind but no play/fast forward. Servicerhad replaced flex board FP-53 and still had same problem. I could see nooutput out of pin 3 of FP-53. Made an ohm check of continuity and every-thing seemed to measure ok. Found the problem |