Dicas Reparação
Modelo - Chassis CCDTR91
Pesquisa: CCDTR91 Enviar Dica Resolvida
Resultados 23
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CCDTR91 | UNIT STUCK IN SERVICE MODE, BUT DATA IS OK (FOUND VC132 BAD) | VC132 board was bad, and found power switch corroded under theshield. Unit was stuck in service mode, but data was normal. When youturn off standby switch, the VTR is still on. | ||
| Sony | CCDTR91 | APPEARS TO BE IN FORCED POWER MODE BUT ISN'T (VC132 WAS BAD) | Unit seems to be in forced power mode (CAM & VTR). By viewingthe LANC jig, you will see VTR/CAMERA both on. On page D, address 21the data is 00 (normal). The mode control IC is OK. Isolated problem toVC132 board. | ||
| Sony | CCDTR91 | NO FOCUS, NO ZOOM (FOUND PS501 OPEN) | Unit has no focus or zoom functions. | ||
| Sony | CCDTR91 | NO E -E CAMERA MODE WOULD COME ON / RESOLDER-REINSTALL L651 | Camera section would come on, blink, but no pix thru V/F orvideo out. | ||
| Sony | CCDTR91 | NO EJECT CAUTION MODE / BAD LOADING MOTOR BLEW PS501 (VS-99) | Unit cannot eject tape and it is in caution mode. VTR/camerais on. | ||
| Sony | CCDTR91 | NO REC/REC START/STOP SWITCH STUCK CLOSED | No rec. VTR controls inoperative. CC ok. Noticed noelasticity of S/S switch when depressed. Close examination revealedswitch stuck closed. | ||
| Sony | CCDTR91 | EE PIX WASHED OUT. CHARACTERS ROLL ON SCREEN/REPLACE DC-DC | Picture washed out and characters roll in EE mode. | ||
| Sony | CCDTR91 | NO COLOR IN VIEWFINDER IN E-E MODE/ADJUST CT601 | Viewfinder was black and white during E-E mode. Viewfinderhad color in playback. The viewfinder was replaced and the unit stillexperienced the same problem. There was color in the video signal goingto the viewfinder, but I noticed the vectorscope was | ||
| Sony | CCDTR91 | PREMATURE TAPE END DETECTION/RESOLDER CONNECTORS ON SL32 | 5 min tape end comes on too soon intermittent. Is there a similar fix like SB CAM-0333 for the FX310? Please call 612-920-3655 EXT 319. -HQ COMMENTS: Please resolder all connectors on the SL-32 board. Thisusually corrects this problem. | ||
| Sony | CCDTR91 | NO COLOR IN VF DURING RECORD/RESOLDER X601 | This camera would show no color in the viewfinder pictureduring record. It would, though, during playback. This was caused by apoor solder connection at X601 on the VC board. Although the crystal wasoperating it was pulled slightly off frequency by the r | ||
| Sony | CCDTR91 | GLASS ON CCD IMAGER CRACKED | Horizontal line across picture in EVF and playback. I foundthat glass on CCD imager cracked in a half and it created line acrosspicture. So far, I have seen two of this type problem. | ||
| Sony | CCDTR91 | BLACK & WHITE VIEWFINDER VIDEO/REPLACE X601 | There was no color in the viewfinder E-E only. Playback wasok. Found that X601 was drifting. | ||
| Sony | CCDTR91 | IC501 CHANGE | IC501 875284249, description CXP80624A-025R is used. Thispart is not listed in KC system and cannot be ordered. | ||
| Sony | CCDTR91 | NO AUTOFOCUS OR ZOOM/REPLACE IC655 | No autofocus or zoom. | ||
| Sony | CCDTR91 | UNIT WILL NOT GO INTO RECORD WHILE IN STANDBY/CHECK CN451 | Unit is powered up and there is camera video but it will notswitch to record. -Resolder CN451 on DD55 bd. |