Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | CCDTR73 | AFTER CHANGING DRUM, NO PIX | Unit had line in playback. Servicer ordered A-7048-776-A andit was on b/o for 2 mos. Drum was replaced by A-7048-823-A. Servicersays unit has no RF output now and pin configuration on drum is different.Could this be the cause of no RF output? See att | ||
Sony | CCDTR73 | AFTER LANCING, E-E ALL BLUE (HAD TO SET ADD 2B DATA TO 58) | Unit was LANC'd and picture became blue in E-E. | ||
Sony | CCDTR73 | NO PIX CAMERA MODE / RESLDR X701 OFF TIMING GEN IC702 | No picture in EVF or line out during camera mode, justflickering and noise. Found oscillator at timing generator IC702 coldsoldered, producing erroneous frequency. | ||
Sony | CCDTR73 | NO PIX IN VF / RESLD CN203 ON VS BOARD | No pix in playback and rec. | ||
Sony | CCDTR73 | NO PLAYBACK PIX / REPLACE C1167 ON THE HE19 BD | No playback pix, audio ok. | ||
Sony | CCDTR73 | VIEWFINDER INOPERABLE/INPUT DATA IN PAGE "D" ADD'S BO TO BB | No color in viewfinder. | ||
Sony | CCDTR73 | BATTERY DOWN ADJUSTMENT DOES NOT WORK | The procedure for the bat. down is incorrect in the SM. Referto the CCD-TR42/TR70/TR72/TR82 Supppplement-1, the procedure in theCCD-TRV30/TRV40/TRV70 SM or the procedure in the CCD-TR23/TR33 SM. | ||
Sony | CCDTR73 | NO FUNCTION AT ALL; NO EVF / RESOLDER CN504 ON THE VS125 BD | You hear a beep when changing from VTR mode to camera mode,but no function at all and no EVF. Found bad CN504 on VS125 board. -SOLUTION :Resolder CN504 on VS125.- HQ Comments: CN504 is the connector between the DC to DC converter andthe VS bd. No volt | ||
Sony | CCDTR73 | NO EJECT/ DRUM RAMPS UP/ REPLACE X502 OFF OF IC505 | When powering up unit will spin the drum and stop. No otherfunctions work. After resoldering IC505 same problem. Isolated problemon servo board VC125, and found X502 not oscillating. |