Dicas Reparação
Modelo - Chassis CCDM8U
Pesquisa: CCDM8U Enviar Dica Resolvida
Resultados 45
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CCDM8U | P/N | No part number in manual for several springs used in gripass -HQ COMMENTS: Please refer to Supplement 2 Page 78 Ref. No. 69 (nextto 68) P/N 3-695-457-01, Ref. No. 93 (below 66) P/N 3-695-766-01,Ref. No. 98 (to the left of 70) P/N 3-303-890-01. | ||
| Sony | CCDM8U | NO CAPSTAN FG, DEFECTIVE FG GENERATOR | Found 3 or 4 units with no capstan FG signal. Can FG genera-tor be replaced separately? -HQ COMMENTS: The FG generator is not available separately. Pleaseorder the complete capstan motor. | ||
| Sony | CCDM8U | CASSETTE COMPARTMENT WILL NOT LOCK DOWN | Unit check out OK using mode selector jig. Replaced sysconmicroprocessor, no help. -HQ COMMENTS: Check eject timing chart as indicated on Pages 137, 138 ofOperation Manual. Also, place unit in eject mode using mode selector jig.Then check Pins 33, 34, | ||
| Sony | CCDM8U | NO LUMINANCE ONLY COLOR | No luminance, only color. | ||
| Sony | CCDM8U | DOES NOT EJECT TAPE | Unit does not eject tape fully out of cassette compartment. | ||
| Sony | CCDM8U | PICTURE LOOKS RED AND WASHED OUT ON OUTDOOR SCENES | Found iris was stuck in open position. | ||
| Sony | CCDM8U | NO FUNCTION | With unit turned on, battery light would blink, no otherfunctions. | ||
| Sony | CCDM8U | NO COLOR DURING RECORDING | The recording contained no color. Found problem caused by nosubcarrier clock input at pin 17 of the ED-11 board. Traced problem to apoor solder connection at IC771 on the VC-4 board. Resoldering the pinsrestored normal operation. When camera section | ||
| Sony | CCDM8U | WIND SCREEN | We have been getting a lot of request for the wind screenwhich detaches from the mic. Will a part number be issued for the windscreen? -HQ COMMENTS: A S/B will be issued for the following models: CCD-V8 2-536-720-01 CCD-M8U X-2536 | ||
| Sony | CCDM8U | PART NUMBER FOR FP-10 FLEX CONNECTOR | S/M does not show P/N. Please inform. -HQ COMMENTS: P/N is A-7070-149-A. | ||
| Sony | CCDM8U | NO EJECT | Capstan and drum rotate erratically during EJECT mode. | ||
| Sony | CCDM8U | BATTERY WILL NOT EJECT FROM COMPARTMENT | Battery will not eject from unit due to small plastic Tshaped insert located inside compartment. Apparently part is to keepbattery from rattling in compartment. | ||
| Sony | CCDM8U | MICROPHONE COVER P/N | There is no parts breakdown for the mike and to replace thecover only which snaps on, you have to replace the whole mike assembly.Could you get us the part # for the mike -HQ COMMENTS: The microphone hoods will be available shortly from KCP.The hoods ca | ||
| Sony | CCDM8U | TAPE TRANSPORT JAMMED (NO MECHANICAL MOVEMENT) | Tape transport sec jammed unit totally inoperative. Dis-assembled entire transport sec to find gear B damaged teeth sheared off.Plastic gear meshed with metal gears. LS chassis had to be removed whenchassis was not in ready mode due to the damaged gear | ||
| Sony | CCDM8U | NO EJECT AND INTERMITTENT TALLY AND STANDBY LAMP OPERATION | 1) Unit would not eject. 2) Tally lamp (D114) and stand-bylamp (D116) on FP-16 board work intermittently. |