Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | CCDFX620 | PREMATURE TAPE END SIGNAL (FOUND END SENSORS ON LS33 BAD) | Tape end signal comes on prematurely. Resoldered SL-31 boardconnectors and connector to SL-31 board on LS-33 board and oiled LSconnector with FL oil and problem was still present. | ||
Sony | CCDFX620 | UNIT IS DEAD / REPLACE Q505 ON THE CS44 BOARD | Unit dead | ||
Sony | CCDFX620 | UNIT WILL NOT POWER UP/RE-INSTALL Q504 | Found Q504 missing from PCB, looked like poor soldering job. | ||
Sony | CCDFX620 | STRAP MOUNT BROKEN/CABINET SIDE | Strap broken off cabinet. Replaced left cabinet. | ||
Sony | CCDFX620 | PART NUMBER FOR TELE/WIDE SWITCH INCORRECT/1-692-257-21 | Drawing in S/M is incorrect showing plug in flex connector andswitch board. Flex board is actually part of switch assy. | ||
Sony | CCDFX620 | DISTORTED PIX IN PLAYBACK/REPLACE HEAD AMP IC001 | Picture was distorted in playback with self recordings.Pre-recorded tapes played back fine. Found problem to be no ATF signalbeing recorded onto the tape. ATF record signal was at pin 18 of IC501but extremely low at pin 46 of IC001 the head amp. The D | ||
Sony | CCDFX620 | HAND GRIP BROKEN / REPLACE CABINET X-3941-4811 | Hand grip broken from cabinet assembly. | ||
Sony | CCDFX620 | HAND GRIP POST BROKEN/REPLACE LEFT CABINET | The two plastic posts on the inside of the hand grip arebroken. This is a very weak point on the hand grip. | ||
Sony | CCDFX620 | AVAILABILITY OF FP-443 BOARD | What is the part number for the FP-443 flex board? -HQ COMMENTS: This part is not available separately. It is supplied withthe LS Chassis Assy (X-3941-265-1). |