Dicas Reparação
Modelo - Chassis CCDFX410
Pesquisa: CCDFX410 Enviar Dica Resolvida
Resultados 41
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CCDFX410 | UNIT CHATTERS WHEN FULLY LOADED/UNLOADED | Using the mode box when unloading STOP and FWD lights wouldkeep repeating. | ||
| Sony | CCDFX410 | CCD-FX SERIES VIEWFINDERS/CCD-FX620 S/M | |||
| Sony | CCDFX410 | WILL NOT LOAD/UNLOAD | IC-510 appeared bad and it would not turn on Q-509. Put unitin page four address OE DATA 01 then Pause. Then address II DATA OC forUnload to troubleshoot IC-510. Had input to pin 14 and no output. Appliedsix volts on Q-509 collector and unit unloaded. | ||
| Sony | CCDFX410 | CAPSTAN OVERSPEEDING | Capstan overspeeds. Mechanism will not operate. Apparentloss of F.G. | ||
| Sony | CCDFX410 | AVAILABILTY OF FP-442 FLEX BOARD | We are getting many requests from the field for the partnumber for the FP-442 Flexible board. Is this part available? -HQ COMMENTS: This part is listed in the CCD-FX620 Service Manual page163. Part number is 1-641-639-13. | ||
| Sony | CCDFX410 | WEAK LUMINANCE AND SYNC IN CAMERA VIDEO | Dark picture with loss of some horizontal sync. Picture doesnot roll luminance off the CS-31 board is ok. Checked luminance atC-071 into the capacitor is fine and out of the capacitor is weak withvery little sync. | ||
| Sony | CCDFX410 | CAMERA VIDEO VERY DISTORTED/LINES IN PICTURE/RANDOM NOISE | Found pulses of IC-801 pins 30-335 distorted. Replaced IC-801from a scrap board with the same problem. Checked pulses pins 30-35still bad. | ||
| Sony | CCDFX410 | RED PICTURE FROM CAMERA | Unit played back pre-recorded tapes fine. Camera sectionwould output red picture with same video detail (looking solarized).Checked IC-802 A/D converter. There was no activity on pin 1 of IC-802 -0vdc. | ||
| Sony | CCDFX410 | JAMMED | Unit came in jammed. Gary Kilbourn found the cam gear hadseveral broken teeth. | ||
| Sony | CCDFX410 | RAINBOW STRIPED CAMERA VIDEO | CCD was missing the V-2 signal (CN-801 pin 8). Checked pin 17IC-804 V2 missing check pin 3 XV2 signal missing checked pin 30 IC-801XV2 missing. Checked pin 44 (XSH2) & pin 34 (XSG2) of IC-801 ok.Checked DC voltage pin 30 (IC801) should be 0.2 volts but | ||
| Sony | CCDFX410 | NO FORWARD DIRECTION | No forward direction the reverse is ok. Chu in Costa Mesatold me he had the above problem and found cold solder joint on the takeup reel sensor. |