Dicas Reparação
Modelo - Chassis CCDF55
Pesquisa: CCDF55 Enviar Dica Resolvida
Resultados 85
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CCDF55 | SCREEN DATA JITTERING | The screen data is jittering. | ||
| Sony | CCDF55 | INTERMITTENT SHUT DOWN | Unit would intermittently shut down after displaying head clogdetection. Further investigation showed the unit was unable to detectspeed during Cue and Review. Went to IC-507 pin 1 was 5V not 0V. Pin 2never went to 2.9V and pin 1 never output the dete | ||
| Sony | CCDF55 | ERROR ON SERVICE MANUAL PAGE 80 | No Playback or Record this was customer's complaint. Wouldnot playback picture checked pin 16 CN-501 on SS-100 board no PlaybackRF. After further checking, Playback RF in actually pin 17. -HQ COMMENTS: Please correct your service manuals (Page 80) to | ||
| Sony | CCDF55 | STRANGE CHARACTERS IN VIEWFINDER DISPLAY | |||
| Sony | CCDF55 | EVF PART NUMBERS | When replacing CRT (1-546-085-11), listed on page 104, nopart number listed for the holder. Used part numbers listed in CCD-F36supplement No. 3 manual:Ring 3-724-570-01Lock 3-724-549-01Holder X-3724-509-1Need all three when replacing the | ||
| Sony | CCDF55 | DEFECTIVE CCD IMAGER -- SPOT IN PICTURE | One bad pixel in picture in the form of a white spot on theupper right hand corner of the picture. The bad imager was stamped 2J. I ordered another one and it had the same problem in the same generalarea and it was also stamped 2J. The second one I ord | ||
| Sony | CCDF55 | BENT REEL SHAFT | Tape drags - no rewind. Found supply reel shaft bent to out-side of frame. RK Gear would not engage supply reel. | ||
| Sony | CCDF55 | INTERMITTENT OPERATION | Capstan motor intermittently speeds up, causing intermittentoperation of unit. CN-506 and 507 board-to-board connectors showcorrosion in between where they hinge. | ||
| Sony | CCDF55 | NO PICTURE | No playback picture. | ||
| Sony | CCDF55 | INTERMITTENT OPERATION | The unit will operate intermittently. | ||
| Sony | CCDF55 | REEL GRINDING DURING THREADING | Capstan motor high speed when set to play made a reel grindingnoise during threading. | ||
| Sony | CCDF55 | NO VIDEO FROM CAMERA | No video from camera. | ||
| Sony | CCDF55 | TECH TIP FOR SERVICING WITH MODE SELECTOR III | When working on CCD-F55s, there is no way to hook up the load-ing motor to the mode selector. Technical Department is researching aboutgetting a connector which could hook two cables to the mode selector. | ||
| Sony | CCDF55 | SOMETIMES NO THREADING - MAY/MAY NOT START AFTER THREADING | Sometimes no threading, if it threads it may or may not start.If it starts, play may stop. Freezing SS-100 board would duplicate. | ||
| Sony | CCDF55 | WOULDN'T GO INTO RECORD POWER UP | Unit will not go into record power up. S-900, the Stand-byswitch had cold solder joints. |