Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | CCDF50 | NO PICTURE ON PLAYBACK | After five minutes of warm up, the picture on Playback will godark. Sound was fine. | ||
Sony | CCDF50 | WILL NOT EJECT | Unit will start to eject. The capstan motor runs very fastfor a split second then unit shuts down. A problem with FG hall devicecaused IC-006 (FG pre amp) to have no output. Pin 16 IC-006 measured 2.55volts instead of 2.6 volts. | ||
Sony | CCDF50 | NO CAMERA OR PLAYBACK VIDEO OUT | Unit had no camera, playback or EE video. Signal was goodgoing into input select IC-362 pin 28 (VA-Board). Video looked clipped atpin 11 and no signal was present at pin 4. Changing IC-362 had no effect.Found no serial data I/O at pins 20-23. Traced | ||
Sony | CCDF50 | NOISY PICTURE | One head output is missing. | ||
Sony | CCDF50 | THE MOUNTING PLATE FOR THE A/V IN/OUT JACKS IS UNAVAILABLE | Is there a part number for the mounting bracket for theaudio/video in/out jacks? -HQ COMMENTS: The entire PCB must be ordered to obtain this part. | ||
Sony | CCDF50 | PART NUMBER FOR FLEX CABLE | Need part number for flex cable between VC-62, VC-63 andW-701. -HQ COMMENTS: The part number is 1-559-927-11. | ||
Sony | CCDF50 | NO FUNCTION | Report that two units had no function. | ||
Sony | CCDF50 | PARTIALLY EJECTS AND DAMAGES TAPE | Intermittent shutdown - would eject part way then reloadeating tape. | ||
Sony | CCDF50 | ZOOM CONTROL DID NOT WORK IN WIDE ZOOM | Zoom did not work in wide position. | ||
Sony | CCDF50 | SERVICE MODE AND ADJUSTMENT INFORMATION | Servicer has requested service mode and adjustment proceduresfor this camera. How is the unit put in the service mode? Are the codesthe same as the V11? -HQ COMMENTS: Please refer to CCD-F50/F70 supplement 1. | ||
Sony | CCDF50 | LCD DISPLAY INOPERATIVE | Could not set date/time or reset counter. |