Dicas Reparação
Modelo - Chassis AV25S1EK
Pesquisa: AV25S1EK Enviar Dica Resolvida
Resultados 17
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Jvc | AV25S1EK | Field collapse | Resolder TDA3654 as joints appear good but on application of soldering iron show to be dry | ||
| JVC | AV28S1EK AV25S1EK MX2 | Width & E-W faulty | Replaced memory chip for electronic screwdriver - 24C01A/P IC1707 | ||
| JVC | AV28S1EK AV25S1EK MX2 | St/by light changes col but no line drive | No supply to line dr tfmr as R903 2k2 hi res (switches st/by tr Q902) | ||
| JVC | AV25S1EK MXII | Unstable pic with line jitter | Video o/p from IF module has ragged sync pulses - 1µ elect cap in AGC feed | ||
| JVC | AV25S1EK Mk2 | Always comes on in st/by - sometimes at full vol | EEPROM IC104 corrupt - pt no CAT93C66P | ||
| JVC | AV25S1EK | Shuts down immediately after sw on | D521 BY228 s/c, C468 47µ , R526 0R2 | ||
| JVC | AV25S1EK | Shuts down at sw on | D521 BY228 s/c, C468 47µ, R526 0R22? | ||
| JVC | AV25S1EK | NO LINE DRIVE | R903 2.2k BASE BIAS TO Q902 SLIGHTLY HIGH | ||
| JVC | AV25S1EK | Led goes red, then green then off at sw on - no start | R526 39R, C458 4µ7 50v & D521 BY228 in E/W cct | ||
| JVC | AV25S1EK | LED COMES ON AND THEN GOES RED THEN OFF | CHECK FOR S/C E/W STAGE R526, C458 AND D521 39 OHM, 4.7MFD50V AND BY228 | ||
| JVC | AV25S1EK | FRAME COLLAPSE | REPLACE FRAME IC TDA3654 | ||
| JVC | AV25S1EK | Field collapse | TDA3654 FOP chip | ||
| JVC | AV25S1EK | Dim pic with green tint | No volts at IC201 contrast control pin as C1206 3µ3 leaky | ||
| JVC | AV25S1EK | DIM PIC | C1206 LEAKY 3.3mfd | ||
| JVC | AV25S1EK | Dead or int dead - front LED operates ok & HT/LT readings ok | Check R903 & 904 2k2 & dry joints on st/by trs Q902 & 901 near them |