Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | SLV575UC | WILL NOT EJECT TAPE | Unit would not eject tape. Found cam gear defective. | ||
Sony | SLV575UC | FUNCTIONS SCRAMBLED/TAPE SKEWING | Push Stop and unit would play, push Play unit stops. Whenplaying back, the tape skewed through the tape path. | ||
Sony | CCDV99 | INTERMITTENT NO COLOR | E-E color looks ok but on playback color intermittently cutsout. This is very intermittent and difficult to reproduce. | ||
Sony | KV27DS20 | CHANNELS DRIFT, REPLACE TUNER AND IC-101 | Channel would drift. Servicer replaced IC-101 which did notsolve the problem. Found tuner defective. | ||
Sony | STRAV550 | PART NUMBER CORRECTION IC-402 | Part number for IC-402 on main PCB, location C/5, isincorrect. | ||
Sony | STRAV57 | PART NUMBER CORRECTION IC-402 | Part number for IC-402 on main PCB location C/5 is incorrect. | ||
Sony | CDX7560 | SERVICE MANUAL ADJUSTMENT SECTION ERRORS | The adjustment section of the manual has several errors. Onpage 6 shouldn't spindle height be closer to .95mm than .95cm? Also,entering the service mode requires you to press and release the resetbutton while simultaneously holding down the other 2 key | ||
Sony | CCDV701 | SLOW HORIZONTAL PICTURE JITTER | Recording and Playback picture exhibited horizontal jitter.The problem was traced to missing back tension spring. Could not find oldspring. I'm not sure if it came off or was never put in (camera is new). | ||
Sony | CDP470 | UNIT WON'T PLAY DISC, MANUFACTURING DEFECT IN CABLES | Sled inoperative. When limit switch is closed manually, nofocus search. | ||
Sony | STRD2020 | UNIT IN PROTECT MODE AFTER POWER UP, BAD GROUND CONNECTION | Unit in protect, B+ was at +56.6V and B- was at -70.1V. | ||
Sony | TAAV501 | UNIT GOES INTO PROTECT - C700 FAULTY P/N 1-161-494-00 | Unit goes into protection immediately after power up. | ||
Sony | CCDV5000 | LCD FULLY LIT UP - INTERMITTENT | Sometimes by squeezing or flexing the cabinet all segments ofthe LCD would go on or sometimes the deck would even go into Rewind. Ifthe unit was disassembled, it would not fail. I notied that one cabinetscrew would connect the handle bracket (Ref. No. | ||
Sony | CCDF501 | AF ADJUSTMENT COVER PART NUMBER | Could you please get me the part number for the small discwhich covers the auto-focus distance adjustment screw? -HQ COMMENTS: The part number for this is the same as for the CCD-F40 itis 3-725-181-01. There is stock available in KCP. | ||
Sony | CCDV701 | AF ADJUSTMENT COVER PART NUMBER | Could you please get me the part number for the smaller discwhich covers the auto-focus distance adjustment screw? -HQ COMMENTS: This part is called the AF Cap and the part number is3-942-193-01. There is stock available in KCP. | ||
Sony | KV19TS20 | NO HIGH VOLTAGE, REPLACE IC-301 | No high voltage - flyback making noise. |