Dicas Reparação
Modelo - Chassis
Pesquisa: Enviar Dica Resolvida
Resultados 81408
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | LBTD560 | SPEAKER BOXES NOT REPAIRABLE | Grille is glued to speaker box. Cannot disassemble box to replace speakers. | ||
| Sony | HCDH550M | NO POWER TO DECK B - REPLACED MICRO | No power to deck B. | ||
| Sony | HCDD560 | NO POWER | This is another unit that came in with fuse F1903 open. Found oscillation (about 600KHz) on output IC when volume is up full on unused function. -SOULUTION: Wrapped wires 7&8 to a wire cable from Power Amp BD to Main B | ||
| Sony | HCD251 | POWER TRANSFORMER FUSIBLE LINK OPENS - REPLACE T901 | The fusible link within the transformer opened. This is thesecond time in 60 days. | ||
| Sony | XRC720 | UNIT ALWAYS SELECTS METAL REGARDLESS OF TAPE USED | The tape type selection is remaining in the metal biasmode. This condition occurred regardless of the tape used,e.g. it happens using normal tape. | ||
| Sony | XR6450 | UNIT WILL NOT POWER UP | Unit will not power up. Found an open trace between connectorCN900 pin 2 and junction of R650. There is no apparent cause of failure,but most of the time the trace is open, and at the same time capacitorC932 blows out. | ||
| Sony | RMX45RF | PART AVAILABILITY: HIDEAWAY/WIRED DISPLAY | The manual has no part number for Hideaway units and WiredDisplays that are defective and cannot be repaired to component level. | ||
| Sony | MDX400 | PART AVAILABILITY: HIDEAWAY UNIT | The manual has no part number for Hideaway unitsthat are defective and cannot be repaired to component level. | ||
| Sony | MDX100 | COOLING FAN VERY NOISY (REPLACING FAN FIXED PROBLEM) | The cooling fan used in the MDX-100 was making a mechanicalnoise. | ||
| Sony | EXCD31 | LOADS DISC, WON'T CLAMP (CLEANED AREA BETWEEN REF 161 & 159) | Would load disc, but not clamp it. Found that the D-lever(ref. 161) was sticking, which prevented the TR circular rack gear toengage (this rack gear is not referred to in the service manual, but isatached to TR tension spring ref. 163). | ||
| Sony | EXCD1RF | PART AVAILABILITY: HIDEAWAY/COMMANDERS | The manual has no part number for Hideaway units and Wiredcommanders that are defective and cannot be repaired to component | ||
| Sony | EXCD1RF | DISPLAY MAIN BOARD PART NUMBER | The part number shown for the EXCD-1RF Display Main Board isthe same as the part number shown for the Off button (ref#352). | ||
| Sony | CDXC810DSP | LOADS DISC, WON'T CLAMP (CLEANED AREA BETWEEN REF 161 & 159) | Would load disc, but not clamp it. Found that the D-lever(ref. 161) was sticking, which prevented the TR circular rack gear toengage (this rack gear is not referred to in the service manual, but isatached to TR tension spring ref. 163). | ||
| Sony | CDXC710 | LOADS DISC, WON'T CLAMP (CLEANED AREA BETWEEN REF 161 & 159) | Would load disc, but not clamp it. Found that the D-lever(ref. 161) was sticking, which prevented the TR circular rack gear toengage (this rack gear is not referred to in the service manual, but isatached to TR tension spring ref. 163). | ||
| Sony | CDXC610 | LOADS DISC, WON'T CLAMP (CLEANED AREA BETWEEN REF 161 & 159) | Would load disc, but not clamp it. Found that the D-lever(ref. 161) was sticking, which prevented the TR circular rack gear toengage (this rack gear is not referred to in the service manual, but isatached to TR tension spring ref. 163). |