PT Service Mode (Modo de Serviço)

SANYO

PT90

TV

Service Mode

PT90 SERVICE MODE : MENU, FEATURES,LANGUAGE AND 1923, TO STORE STBY

PHILIPS

TV

Service Mode

1-Interligue os “jumpers” 9040 e 9041 2-Ligue o televisor pela chave geral 3-A tela irá apresentar um retângulo verde com a indicação SDM 4-Após acessar o modo SDM, retire o curto – circuito entre os “jumpers” 9040 e 9041 5-Pressione no televisor VOL + e VOL -, por aproximadamente 3 segundos 6-No lugar de SDM, aparecerá a indicação SAM. 7-Escolha o item desejado use as teclas UP e DOWN 8-Para ajustar o valor selecionado use as teclas LEFT e RIGHT 9-Para retornar ao menu principal, aperte a tecla MENU l0-Para sair do modo de serviço e memorizar os ajustes aperte a tecla POWER no controle remoto.

PHILIPS

TV

Service Mode

1-Retire o cabo de força da tomada 2-Ligue por um fio o pino 1 da EPROM 24C08 a terra 3-Insira o cabo de força na tomada e ligue o televisor 4-Selecione o item desejado com as teclas CANAL + E CANAL – 5-Ajuste o valor desejado com as teclas VOL+ e VOL – 6-Para sair do modo de serviço, desligue pelo controle remoto e retire o cabo de força da tomada.

PHILIPS

PT

TV

Service Mode

Com o tv ligado, digite no controle remoto: 062596 + menu, tudo em sequência.

PHILIPS

20PT424A

CTV

Service Mode

Short circuit pin 1 of the EEPROM (24C08) to ground

PHILIPS

21PT263A

CTV

Service Mode

Short circuit pin 1 of the EEPROM (24C08) to ground

Philips

MG7.1

CTV

Service Mode

Use the standard remote control an key in a special sequence 0 6 2 5 9 6 followed by pressing the 'MENU' button. If the main menu also appears with the service menu just press 'MENU' again to clear it. The other way is to short the two service pins on the signal panel (pins 2 and 3 of connector 0356). The advantage of this last method is that all the software protections are turned off.

Grundig

VCR

Electronic Lock Cancel

Press the 'CODE' button on the remote control handset. Enter the numers 4 9 3 4 on the remote control handset in this order and confirm with the 'OK' button. Press the 'STAND-BY' button or disconnect the recorder from the mains.

Grundig

VCR

Electronic Lock Cancel

Press the 'CODE' button on the remote control handset. Enter the numers 4 9 3 4 on the remote control handset in this order and confirm with the 'OK' button. Press the 'STAND-BY' button or disconnect the recorder from the mains.

Grundig

VCR

Electronic Lock Cancel

Press the 'CODE' button on the remote control handset. Enter the numers 4 9 3 4 on the remote control handset in this order and confirm with the 'OK' button. Press the 'STAND-BY' button or disconnect the recorder from the mains.