DV5107H Service Mode (Modo de Serviço)
Modelo:DV5107H
Marca
Mod.
Ch.
Tipo
Modo
Proced.
File
Sharp
CTV
Service Mode
1. Connect a test pattern to the antenna terminal 2. Tune to this signal 3. Turn the receiver on 4. Connect a jumper wire momentarily between terminals 2 (GND) and 6 (Service) of connector of CN1 on the Video unit. Note that the wire is used just like a passing contact switch 5. 'SHARP Software Service Ver' will appear on the screen Use the channel up and down buttons to move between the options Use the volume control buttons to change the data Use the standby button on the remote control to store the data Turn the receiver off at the mains to exit the service mode
Sharp
CTV
Service Mode
1. Connect a test pattern to the antenna terminal
2. Tune to this signal
3. Turn the receiver on
4. Connect a jumper wire momentarily between terminals 2 (GND) and 6 (Service) of connector of CN1 on the Video
unit. Note that the wire is used just like a passing contact switch
5. 'SHARP Software Service Ver' will appear on the screen
Universal LED TV Service Mode
Most universal led tv boards check:
- Menu → 1147
- Menu → 2580
- Source → 2580
All LED TV Service Codes
- Menu → 1147
- Menu → 1185
- Menu → 1183
- Menu → 2580
- Menu → 1187
- Menu → 7050
- Menu → 8202
- Menu → 7343
- Menu → 2008
- Menu → 1999
- Menu → 0000
- Menu → 1167
- Menu → 1199
- Menu → 1234
- Menu → 2387
- Menu → 8893
- Menu → 2383
- Menu → 4725
- Source → 3138
- Source → 2580
- Source → 2585
- Source → 7342
- Source → 2583
- Source → 2283
- Source → 2285
- Source → 3195
- Source → 3137
- Source → 0000