SHARP Service Mode (Modo de Serviço)

Sharp

CS

CTV

Service Mode

1. Connect a test pattern to the antenna terminal 2. Tune to this signal 3. Turn the receiver off using the mains button 4. Press the volume down and channel up buttons on the front of the receiver at the same time 5. Keeping these buttons pressed, turn the mains on 6. When the set starts up it will be in service mode 7. Release the two buttons Use the channel up and down buttons to move between the options Use the volume control buttons to change the data Use the standby button on the remote control to store the data

Sharp

CA10

CTV

Service Mode

1. Connect a test pattern to the antenna terminal 2. Tune to this signal 3. Turn the receiver off using the mains button 4. Press the volume down and channel up buttons on the front of the receiver at the same time 5. Keeping these buttons pressed, turn the mains on 6. When the set starts up it will be in service mode 7. Release the two buttons Use the channel up and down buttons to move between the options Use the volume control buttons to change the data Use the standby button on the remote control to store the data Turn the set off at the mains to exit the service mode.

Sharp

CA1

CTV

Service Mode

1. Connect a test pattern to the antenna terminal 2. Tune to this signal 3. Turn the receiver off using the mains button 4. Press the volume down and channel up buttons on the front of the receiver at the same time 5. Keeping these buttons pressed, turn the mains on 6. When the set starts up it will be in service mode 7. Release the two buttons Use the channel up and down buttons to move between the options Use the volume control buttons to change the data The data is stored automatically at switch off To exit the service mode, press the standby button on the remote control.

Sharp

4BS-C

CTV

Service Mode

1. Connect a test pattern to the antenna terminal 2. Tune to this signal 3. Connect a jumper wire between terminals 2 (GND) and 6 (Service) of the service slot on the Text Unit 4. SERVICE SOFTWARE will appear on the screen 5. Remove the jumper wire

Sharp

BCTVA

CTV

Service Mode

1. Connect a test pattern to the antenna terminal 2. Tune to this signal 3. Connect a jumper wire between terminals 2 (GND) and 6 (Service) of the service slot on the Video Unit 4. SERVICE SOFTWARE will appear on the screen 5. Remove the jumper wire

Sharp

S3B

CTV

Service Mode

1. Connect a test pattern to the antenna terminal 2. Tune to this signal 3. Connect a jumper wire between terminals 2 and 6 of the service slot on the video PWB 4. Press the MODE button on the remote control 5. 'SERV' will appear on the screen 6. Remove the jumper wire Use

Sharp

5BSA

CTV

Service Mode

1. Connect a test pattern to the antenna terminal 2. Tune to this signal 3. Turn the receiver off using the mains button 4. Press the volume down and channel up buttons on the front of the receiver at the same time 5. Keeping these buttons pressed, turn the mains on 6. When the set starts up it will be in service mode - 'SERV' appears on the screen 7. Release the two buttons Use the channel up and down buttons to move between the options Use the volume control buttons to change the data The data is stored automatically at switch off

Sharp

CTV

Service Mode

Locate place for 2 buttons on local keyboard (main board) S754-MODE and S755-PRESET. Enter: short S754 (-SERV-). Commands: CH +/-. Store: short S755.

Sharp

CTV

Service Mode

Press and hold buttons VOL- and PR+ on the local keyboard and then switch on with main switch. Store: 'POWER'.

Sharp

Euro-DS1

CTV

Service Mode

Short conntacts 2 & 6 on Digi Modul Service Slot and then press button 'MODE' on RC. Store: (romb-symbol) on RC. Exit: standby, switch off, switch on, remove short.