Service Mode (Modo de Serviço)

Insira Marca, Modelo ou Chassis.



Marca
Mod.
Ch.
Tipo
Modo
Proced.
File
Toshiba
LCD
Modo Serviço
Para acessar o menu de serviço seguir o procedimento abaixo
1 - No controle remoto pressionar a tecla MENU;
2 - Selecionar menu IMAGEM;
3 - Selecionar opção CONTRASTE;
4 - No controle remoto pressionar a sequência numérica 1950;
5 - Nesse momento o menu de serviço estará disponível.
6 - Selecionar a opção Service Menu.
CCE
TV
Service Mode
Ligue ao terra o pino 78 do IC101 (momentaneâmente) ou pressione a tecla no serviço de controle remoto (veja a descrição serviço de controle remoto).->Selecione a opção de ajuste pressionando as teclas CH^ ou CHv do controle remoto do painel frontal da televisão ou use o serviço de controle remoto (veja a descrição serviço de controle remoto). Ajuste a opção desejada pressionando as teclas VOL > ou < Para sair do MODO FÁBRICA, use a tecla OSD/OUT do controle remoto.
PANASONIC
TV
Service Mode
POWER OFF
MUTE 1»8»2
POWER ON
HITACHI
TV
Service Mode
Turn TV Off
Press and hold "MENU" key, press and release MASTER POWER BUTTON
Keep pressing "MENU" key until SERVICE MENU appears on screen
PANASONIC
TV
Service Mode
Press (VOL -) on TV then press (INFO) in remote 3 times in 2 seconds.
PHILIPS EMERSON MAGNAVOX
TV
Service Mode
1.Turn ON the Power.
2. Press MENU button to display Setup Menu.
3. Select FEATURES.
4. Select CURRENT SOFTWARE INFO.
5. Insert 0,4,2,5,7,4 and INFO buttons on the remote.
The service mode screen will appear.
SHARP
TV
Service Mode
1. Connect a test pattern to the antenna terminal.
2. Tune the receiver to this signal.
3. Turn the receiver off using the mains switch.
4. Press volume down and channel up buttons on the front of the receiver at the same time.
5. Keeping these buttons pressed, turn the mains on.
6. When the set starts up it will be in Service Mode. 7. Release the two buttons.
# Use the channel up and down buttons to move between the options.
# Use the volume control buttons to change the data.
# To store the data, use the stand-by button on the remote control.
# To exit the Service Mode, turn the receiver off using the mains switch.
SONY
TV
Service Mode
1. TV must be in standby mode. (Power off).
2. Press the following buttons on the Remote within a second of each other: DISPLAY->Channel->5->Volume +
TV POWER

The first service menu (TV) displays More information in PDF
EMERSON
TV
Service Mode
1.Turn ON the Power.
2.Press MENU button to display Setup Menu.
3.Select FEATURES.
4.Select CURRENT SOFTWARE INFO.
5.0,4,2,5,7,4 and INFO buttons on the remote.
The service mode screen will appear.
SYLVANIA
TV
Service Mode
1.Turn ON the Power.
2.Press MENU button to display Setup Menu.
3.Select FEATURES.
4.Select CURRENT SOFTWARE INFO.
5.0,4,2,5,7,4 and INFO buttons on the remote.
The service mode screen will appear.