Dicas Reparação




Modelo - Chassis VTX1000R


Pesquisa: VTX1000R Enviar Dica Resolvida
Resultados 10
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonyVTX1000R
NOISE IN PICTURE Interference in picture caused by frequency beating the video.The higher the channel number, the more intense the noise.
SonyVTX1000R
MISPRINT ON SCHEMATIC This unit has a very weak audio. Upon troubleshooting theunit I found out that RV-005, R057 and C061 are not on the schematic. -HQ COMMENTS: We will publish correction on this.
SonyVTX1000R
VIDEO MUTE KX-1901 plays fine with external video but when hooked tothe VTX-1000 it goes into video mute. We found IC005/IF chip in theVTX-1000 to be defective.
SonyVTX1000R
NO CHANNEL CHANGE Would not change channels after approx. 30 minutes playingtime.
SonyVTX1000R
HISS NOISE IN AUDIO Slight hissing noise in audio only on channel 13.
SonyVTX1000R
INCORRECT TUNING OPERATION The customer complaint was the memory worked fine with theexception that it would not remember more than one channel beginning withthe number 3. It would remember any channel beginning with 3 but notmore than one.
SonyVTX1000R
CH 14 WOULD NOT LOCK Cable Ch. 14 could not lock in on a cable co. using HRC cablesystem. AFT is not pulling far enough down to lock on Ch. 14.
SonyVTX1000R
TUNING WOULD NOT LOCK At turn on, unit would display random channels, never the lastchannel which was displayed at turn off. Inspection of circuit revealedno reset pulse at Pin 7 of IC001 on A board. This pulse is supplied fromIC002. Voltage check on IC002 showed only abou
SonyVTX1000R
NO PICTURE Dead tuner 6.8V line is 0V. Found ROSS at the 6.8V regulatoropen.
SonyVTX1000R
NO POWER ON No power-on switching using front panel switch (S802) orremote. Customer claimed power would come on intermittently and thatother functions such as video switching, antenna switching would workerratically (this was not verified). When S802 is depressed


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads