Dicas Reparação




Modelo - Chassis V28


Pesquisa: V28 Enviar Dica Resolvida
Resultados 112
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
Ideal/Slx IDTV28T/IDTV28N/SLX28T2/28N SM2
EW fault then set went dead tripping, R711 on EW panel burntCheck for dry joints on C620 0.47uF, 250V, if dry replace then check Q602 and R618 5K6. Also it is worth replacing Q580 anytime these sets come into the workshop with a BF422
SonyKV28WS2U BE3D
St/by LED flashes twiceM24C32 sm EEPROM replaced (caused by crt flashover?)
SonyKV28WS2U BE3D
Service mode enteringfrom st/by press OSD/5/volume+/tv; TT____ will appear top right. Entering TT38 sets the TV as a 28 inch, TT24 sets TV as PAL I, TT79 for widescreen. MENU gives submenu choices eg geometry; TT00 exits & stores
SonyKV28NX1U
blows LOPTr DJ on L803
SonyKV28LS35U
Reverts to st/by aft initial rush of EHT, LED blinks twiceOver-current error caused by R618 270k in current sensing hi res
SonyKV28DS60U
Lack of widthPS1502 1A cct prot on D1 LH vert panel (now upgraded to 2A)
SonyKV28DS60U
Electronic Screwdriver settingsWith set in st/by, press r/c in order - "display", "5", "Vol+", "TV" - the screen now displays " T T - -". Select "Menu" puts you into service mode
SonyGE-1A KV28DS60U
low width, E-W errorfuse link PS1502 o/c on D1 PCB
SonyGE1 KV28FD1E
Strange menus & graphics int appearResolder conns of micro & Megatext chips, also IC036/37 memory chips
SonyGE1 KV28FD1E
E/E faulty with lack of widthCheck PS1502 fuse on board D1
SonyBE3E KV28FX20
No chan change unless menu pressed firstEPROM chip corrupted - ok once set was autotuned again
SonyBE-3D KV28WS2U
vol goes up or down on its own, channels wipe out of memory, unusual characters on LHSint lockup of IC3, replace with new software type (IC3 TMS27PC0200-15 software 15FMBW706 or later, part number 875945310)
SonyBE-3D KV28WS2U
no soundD613 FMN-G12S o/c (871905838)
SonyBE-3D KV28WS2U
no pic, sound Okno line drive, R870 1R 1W o/c
SonyBE-3D KV28WS2U
int no remoteIR receiver IC900 894179051


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads