Dicas Reparação
Modelo - Chassis V25
Pesquisa: V25 Enviar Dica Resolvida
Resultados 289
Pedir dica reparação
| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | FE-1 KV25X5U | yellow line down screen about 2 inches from RHS | IC301 CXA2060BS (875208838) | ||
| Sony | FE-1 KV25X5U | comes on then goes off, red LED is on | stby IC609 TOP209P u/c | ||
| Sony | FE1 KV25KSU | FRAME IC HOT LINES ON SCREEN | REPLACE C506 0.01MFD | ||
| Sony | FE-1 KV25K5U | not starting up, LED flashes 4 times | T511 breaking down at switch on, replace T511 (145326411 for 25", 145326511 for 29") | ||
| Sony | FE-1 KV25K5U | lines across screen, frame IC running hot | C506 0.01 uF | ||
| Sony | FE-1 KV25K5U | Int reverts to st/by with LED flashing 5 times | CRT internal s/c - replaced under guarantee - very prone to this fault apparently | ||
| Sony | FE1 KV25K5U | Trips off with a crack - LED flashes 5x | CRT faulty | ||
| Sony | FE1 KV25K5U | No R/C op - hset ok | D011 5v6 zener on o/p of Rx leaky | ||
| Sony | FE1 KV25K5U | Dead with LED flashing 4 times | Check for 9v at pins 33 & 34 IC301. If present, check R546 47R 1/2w for o/c (135v Line dr supply) | ||
| Sony | FE KV25X5U | Int no pic with LED flashing 4 times | O/C print from pin 14 of IC301 to first link wire. | ||
| Sony | BE4A KV25T1U | Corrugations and poor EHT stability | LOPTx | ||
| Sony | BE-3D KV25X1U | dead, no LED | IC600 STRS6707, R605 0.27R o/c | ||
| Sony | BE-3D KV25X1U | dead, HT down to 24V | no 5V supply, replace IC604 (875936613) | ||
| Sony | BE-3D KV25X1U | burst of EHT for 5 sec, then dead | LOPTx (145316912) | ||
| Sony | BE3D KV25X1U | LED flahes 19 times at sw on | Multiple devices not acknowledging - Fuse PS603 o/c |