Dicas Reparação




Modelo - Chassis V22


Pesquisa: V22 Enviar Dica Resolvida
Resultados 73
Pedir dica reparação
MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
AmstradCTV2200
Dead.R501 ( 5.6ohm 5W ) o/c.
AmstradCTV2200
Dead No obvious S/C no StBy lightCheck 12V reg IC103 & C524 ( 470uF )
AmstradCTV2200
Dead - int.Drys on T801 , T803 & coil L503.
AmstradCTV2200
Dead - chopper tr s/cR814 27R 20w o/c due to C845 4µ 250v s/c
AmstradCTV2200
Dead - blown fuse.Line o/p Q802 , Chopper Q802 , R501 , F502 fuse.
AmstradCTV2200
Dead - blown fuse.R814 ( 27ohm ) line o/p & chopper transistor , C845 ( 4.7uf )
AmstradCTV2200
Dead - blowing line o/p transistor.Change C845 ( 4.7u f ) , C853/4 ( 1u f ) , C815 ( 0.01u f ) , C862 if on.
AmstradCTV2200
DeadD806 s/c
AmstradCTV2200
DeadDry joint On L503 , Q503 , D806 o/c
AmstradCTV2200
Blows line dr & o/p trdry joints line dr tfmr
AmstradCTV2200
After few hours top of pic compressesC812 ( 0.018uF ) 160V ( in feedback TDA3652 & LA7800 )
SonyCCDV220
SHORT LITHIUM BATTERY LIFE The owners manual says the lithium battery will last about ayear, but this customer has a unit in which the battery lasts only 6months. -HQ COMMENTS: Replace Q-715 DTA-144EK on the FC-15 board with DTA-144TKpart number 8-729-903-29.
SonyCCDV220
ERROR IN BLOCK DIAGRAM Block diagram on pp. 42-43 shows DT-62: SH1, 2 and 3 signalsgoing to SP1, 2 and 3 respectively on IC-251. This is incorrect. Theschematic on page 107 is correct. It refers to SH1, 2 and 3 as Gate 3, 1and 2 on CP-21 bd (HIC251). The actual connections
SonyCCDV220
YELLOW PICTURE/NO BLUE IN EE PICTURE Unit had yellow picture on EE and self-recorded tapes. Noblue was getting through. We checked R-Y and B-Y at W-201. Pin 28 and29, noticing that the B-Y signal was about 5 times greater in amplitudeand did not look like the R-Y. We then checked the SH
SonyCCDV220
VERTICAL (JAIL) BARS IN EE MODE Unit manifested evenly spaced black vertical bars in EE pic-ture or self-recorded tape.


Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads